Electronics Forum | Mon Aug 22 10:15:30 EDT 2011 | davidalvarez
we have never had a problem using no-clean flux as far as far as shorts and testing problems, using high pressure test probes helps overcome this. The problem we have had is if a unit comes back down the line a couple of years later we notice that t
Electronics Forum | Wed Aug 03 10:56:47 EDT 2011 | cyber_wolf
We have a new MPM Momentum. It's hands down the best printer we have ever worked with. Load program--add paste---forget about it. Runs every day all day with no issues what so ever. I come from a "machine background" and the MPM's are much more robus
Electronics Forum | Fri Jun 22 08:36:54 EDT 2012 | jandre1953
Sir: You did not state what kind of screen printer, all the others assumed it was for SMT. We are dealers for ATMA line of screen printing and aux. eqpt. They make a first class, well made press, and are probably the largest in the world now. Over 4,
Electronics Forum | Wed Aug 03 10:09:27 EDT 2011 | geb
Our Samsung CP45FV Neo is out of warranty, but due for its annual calibration/ service, however we are wondering whether it is really needed. The line only runs for 8 hours a day 5 days per week (including setup), so not heavy usage. The manual does
Electronics Forum | Fri Aug 19 02:05:32 EDT 2011 | ppcbs
We have been developing profiles for BGA process going on 14 years now. We have never had to drill holes or resort to any type of destructive methods for BGA assembly, rework or defect analysis. Depending on requirements, i.e BGA rework or BGA assem
Electronics Forum | Thu Aug 04 20:35:33 EDT 2011 | zywong
Hi All, I'm facing a problem is the PCBs are having delamination issue which after SMT reflow process & wave solder process. Dose anybody faced this issue before? The profile setting are correct settings. Some question i wonder: 1) Is that long time
Electronics Forum | Fri Aug 05 09:37:11 EDT 2011 | rgduval
From the fine SMTNet archives: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=12824Message54659 There are a few other threads available, as well, by searchign on PCB Delamination. Delamination post reflow is almos
Electronics Forum | Fri Aug 05 17:34:30 EDT 2011 | bobbydur
Hi, I have a faulty intermec printer CPU board. I'm probably in the wrong place but if anyone can give me some help, I would really appreciate it. I manage to connect an incorrect thermal printhead to the printer and I think it has damaged the CPU
Electronics Forum | Fri Aug 12 09:07:23 EDT 2011 | rway
The rails are being sourced by the regulators. Rails, bus, you can use them interchangeably. As far as what voltage? I have no idea other than my assumptions listed above, but more than likely you will have +/-12V and 5V. Depending on the age of t
Electronics Forum | Fri Aug 12 10:41:04 EDT 2011 | eezday
I believe you've gotten some wise advice about finding a working board rather than attempting repair. If you decide to attempt the repair, checking or replacing the regulators is a reasonable starting point (primary power). The next thing I would d
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835