Electronics Forum | Sun Apr 26 22:47:42 EDT 2020 | autolab
Hello, We would like to manufacture the OBD II port automobile scanner from your firm. What we need from you? To manufacture the PCB, stuffed the components inside and manufacture the housing. Manufacture few samples, then thousands. What we h
Electronics Forum | Wed Apr 29 15:08:24 EDT 2020 | davef
Consider focusing on: * Regional suppliers that are within driving distance * Tier 4 suppliers LT $100M revenues STI used to advertise on SMTnet contact Mark McMeen mmcmeen at stielectronicsinc.com. Other quality suppliers in this tier are: Libra
Electronics Forum | Wed Apr 29 09:27:49 EDT 2020 | zombee
Dear friends, We have a pack of Philips/Assembleon pick and place machines, from CSM and GEM series. I want to set up a "new" Emerald machine, it had been working in Germany 1.5 year ago. It has 3-phase connector. I noticed that it was set
Electronics Forum | Thu Apr 30 09:27:58 EDT 2020 | clockwatcher
I currently have a board that has several wires that need to be soldered into it. Many years ago I remember wave soldering power supply boards that also had many wires. In order to keep the wire insulation out of the solder fillet and keep the wires
Electronics Forum | Thu Apr 30 17:06:19 EDT 2020 | bboyer
So, I have inherited a couple of "vintage" GSM1 machines, and we've got one powered up, trying to see if it even works, before registering the machine and paying Universal some money. It appears several of the safety interlock switches are triggered
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
Electronics Forum | Tue May 05 08:32:34 EDT 2020 | travishemen
Check for nozzles that are stuck up. They may be able to pick the part but will drop the part during placement. I have also seen a feeder several positions over from the part not being picked/placed have a piece of carrier tape sticking up and not
Electronics Forum | Tue May 05 14:57:48 EDT 2020 | greezmky
I will have to check the nozzles to see if they are stuck up, but I don't believe so as I changed them all out a couple weeks ago. I have not went back to the feeder yet because I am not getting vision errors. I was able to see the diodes fly off on
Electronics Forum | Thu May 07 10:48:07 EDT 2020 | greezmky
Yeah my post disappeared as well? I checked to see if there was an offset and there was not. I tried step mode and all was good. I DID get to capture one video in, slow motion, and it shows the part being placed, the nozzle rising, and then when
Electronics Forum | Thu May 07 15:23:57 EDT 2020 | tey422
From what you described of what you seeing from the slow motion is that the part is not actually "placed"; it's more like drops on top of the paste, so it's floating on top only which vibrations would cause it to slips away. Even though I am not fa
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835