Electronics Forum: eliminate component damage (Page 1 of 84)

Heat guns and component damage

Electronics Forum | Tue Jan 31 13:20:15 EST 2006 | mgdrouin1

Does anyone have any information regarding damaged caused to components due to overheating primarily with a heatgun? I'm having a hard time getting engineering to comply. Thanks

Heat guns and component damage

Electronics Forum | Tue Jan 31 13:22:15 EST 2006 | mgdrouin1

Does anyone have any information regarding damaged caused to components due to overheating primarily with a heatgun? I'm having a hard time getting engineering to comply. Thanks

Heat guns and component damage

Electronics Forum | Tue Jan 31 13:41:12 EST 2006 | outgasser

We are currently experiencing problems with delamination during rework/2nd op activity on lead free. I am suspecting this is a result of the use of a heat gun to rework components. My assumption is that the high heat and time in area greatly increa

Heat guns and component damage

Electronics Forum | Tue Jan 31 14:30:38 EST 2006 | Chunks

There is none, since we don't know your part or temp being used. A heat gun CAN be used to remove parts with no damage, if its controled. You need to look up your part on the manufacturers web site, find the process data (time/temp)the part is desi

Heat guns and component damage

Electronics Forum | Tue Jan 31 14:14:03 EST 2006 | samir

Ah, yes. The age-old battle of Production Supervision versus Process Engineering. I guess you just need to tell your Process Engineer, "Pretty please with sugar on top, investigate this f*cking issue."

Heat guns and component damage

Electronics Forum | Wed Feb 01 08:18:28 EST 2006 | slaine

RS sell a heat cun that is fully temperature adjustable buy one of them and pre set it to the right temp then put a calibration sticker over the control.

Heat guns and component damage

Electronics Forum | Tue Jan 31 15:15:13 EST 2006 | russ

Heat guns used improperly will definitely damage components. You must have a controlled heat gun that can be set to the max temp you want pb =215C max, Pbfree maybe 240C max. This heat gun must not be able to be adjusted or you must have total trus

Heat guns and component damage

Electronics Forum | Tue Jan 31 14:58:15 EST 2006 | samir

You see? Chunks, here has the right idea! To the original poster, you need to show this post to your "Desk Jockey" Process Engineer. That's the problem with some Engineers today. They forget everything they learned in Engineering school, they get

Heat guns and component damage

Electronics Forum | Tue Jan 31 15:40:44 EST 2006 | mgdrouin1

Comp is relay. I've pulled the spec. Max 240. Using Leister h/g with manual temp settings from 1-6 (20 - 600C)set by the operator. Gun was set to setting 4. They are using the heat gun to reflow the solder after SMT but before wave. High fai

Heat guns and component damage

Electronics Forum | Wed Feb 01 22:27:16 EST 2006 | KEN

Many relays use soldered post coil terminatins inside the relay. In one case many years ago I found the SMT relay manufacturer used eutectic solder inside their hermetic relay. The SMT relay would fail because the solder balled up on the post, woul

  1 2 3 4 5 6 7 8 9 10 Next

eliminate component damage searches for Companies, Equipment, Machines, Suppliers & Information

2024 Eptac IPC Certification Training Schedule

High Throughput Reflow Oven
Circuit Board, PCB Assembly & electronics manufacturing service provider

World's Best Reflow Oven Customizable for Unique Applications
Void Free Reflow Soldering

We offer SMT Nozzles, feeders and spare parts globally. Find out more
SMT feeders

High Precision Fluid Dispensers