Electronics Forum | Sat May 24 03:32:24 EDT 2003 | Benny
Hi Is there any adapter that adapts between SMT and thru hole ?
Electronics Forum | Tue Feb 27 11:03:09 EST 2007 | Marcin
Hi All, Anybody knows what is the minimum clearance between through hole component and chip component? Problem description: On bottom side of my pcb are only 0603 chip components mounted on glue. One of the component is located very close to hole
Electronics Forum | Wed May 27 10:19:43 EDT 1998 | Jerry
We have no problems but orientation does matter. Orient with longest side of component body perpendicuar to wave. In other words the same preference as with through hole DIPS. Idea is the same as for through hole, that the surface tension will ten
Electronics Forum | Sun Jun 07 09:43:11 EDT 1998 | Bob Willis
There are some guidlines on design and through hole reflow on my web site to download. Also on pin in hole reflow the SMTA Office has a document on using the tecnology. | R&D is currently designing a board with smt components on both sides of the bo
Electronics Forum | Sun Mar 28 18:49:36 EDT 2021 | mekmat544
Hello, I would like to ask you if there is some formula how to calculate PTH hole and annual ring for pin in paste technology? Thank you. Mekmat.
Electronics Forum | Wed Feb 28 21:42:56 EST 2007 | davef
Very smart, Chunks.
Electronics Forum | Tue May 26 22:13:15 EDT 1998 | Pat Copeland
R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommende
Electronics Forum | Wed Feb 28 11:43:20 EST 2007 | realchunks
Marcin, Think outside the box. If you are glueing the SMT part down, why not have an aperture cut in your stencil (or recut a stencil) between the SMT part and thru-hole. Wave solder hates SMT glue. This will get rid of your solder short problem
Electronics Forum | Thu Jun 10 19:10:05 EDT 2021 | kojotssss
Hi, Get your account. https://software.indium.com/stencil-coach/pin-in-paste-apertures.php
Electronics Forum | Wed Feb 28 00:01:47 EST 2007 | Muhammad Haris
Hi, The distance between the two terminations/endings/pads of 0603 (0201)is 0.15mm i.e. lesser than than the distance between the 0603 and through hole i.e. 0.5mm My ques is that, then why its termination doesnot short as it has a minimum distance.A
