Electronics Forum | Mon Jul 20 10:38:18 EDT 1998 | John
| hi....i am new at this technology and would like to know more about smt... | presently iam studying in an engineering field and one of the subject required me to make a studies about smt technologies...if anyone out there know where i might find a
Electronics Forum | Fri Jul 17 21:55:34 EDT 1998 | Sergio Corcuera
| | Is there anybody with knowledge in the process with PHT components (Components with terminals) - Cause with make board with top and bottom side, with SMD and Auto Insertion Technology. So we want to do a Entire Cell with both technology, and wit
Electronics Forum | Tue Jul 14 13:27:40 EDT 1998 | Ben Salisbury
| Why is it not possible to include an image or link from the PCB CE Mart? I think that it would be nice if the poster of an ad for used equipment could include an image of the piece of equipment from the original manufacturers home page and also a l
Electronics Forum | Tue Jul 21 11:21:20 EDT 1998 | JM Coogan
Wayne SANYO is focusing on the bulk feeder design concept developed and licensed by Taiyoyuden Co., Ltd of Japan (instead of the Nitto Kogyo, i.e. pneumatic design). They are making very good progress with 0402C and 0603C components. So far, we hav
Electronics Forum | Thu Jul 09 11:20:24 EDT 1998 | Justin Medernach
| I am looking for a little enlightement with an issue that we have been seeing. We have printed curcuit board with multilayer and HAL finished. | After reflow soldering, we have often "blister phenomenon". | Our reflow profile is normal. Factory
Electronics Forum | Tue Jun 30 12:48:59 EDT 1998 | Upinder Singh
Hi all . Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. I would appreciate if somebody could help me in the stated issue: I am trying to to place one thru hole 20 pin connector along with the SMT components by paste printing an
Electronics Forum | Fri Jul 10 14:23:23 EDT 1998 | Bob Willis
You can get a report and CD ROM on pin in hole reflow assembly from the SMTA main office in the USA. They also have a new report on Double Sided Reflow Design and Assembly. | Hi all . | Thanks to Ryan, Brian , Justin and Dave for the timely help ear
Electronics Forum | Mon Jun 29 13:38:20 EDT 1998 | Russ Miculich
| looking for help with fine-pitch printing for what would be the best settings for printing speed, squeegee pressure, seperation speed. | thanks for you time Brian: As Justin says - the issues are many. However, a good start would be to run at 0.75
Electronics Forum | Thu Jun 25 09:13:25 EDT 1998 | Brad Stapley
| Has anyone seen/used these yet? They seem to have lower coefficient of friction for release of paste and less wear and tear as well as conforming to the board better (plastic has better memory than stainless). Also there is no mesh so a larger ima
Electronics Forum | Fri Jun 19 19:05:06 EDT 1998 | Earl Moon
| What is the smallest a company can be to be ISO ? | Is the cost less for a smaller company ? | What is the smallest I have been, among many other terrific things, an ISO consultant since 1987 (when ISO first came to our shores). During this time
