Electronics Forum | Wed Jul 20 18:08:35 EDT 2016 | freakshow
any help is much appreciated, I keep getting a random shutdown, sometimes a few minutes sometimes after a few hours. "emergency Stop, Please check the stop button" of course no one is touching the stop button and the button does not seem to be faulty
Electronics Forum | Fri Jul 22 15:09:03 EDT 2016 | freakshow
Thank you for the reply, we will trace down the connections and double check them.
Electronics Forum | Tue Jul 26 09:50:21 EDT 2016 | leeg
Could it be the safety relay?
Electronics Forum | Wed Jul 20 22:59:34 EDT 2016 | ttheis
I had something similar to this on a different type of machine but it turned out to be a broken wire terminal connector at the switch causing intermittent connection. Often with safety circuits they are kept high and brought low or interrupted to dis
Electronics Forum | Mon Aug 22 12:25:15 EDT 2016 | mosborne
Ours does the same thing. I was told to update the software to fix the problem, but we just upgraded to a new machine.
Electronics Forum | Thu Aug 11 15:43:45 EDT 2016 | freakshow
yea tried that, and tried replacing other relays too. really frustrating, schematics would be nice..
Electronics Forum | Wed Jul 17 18:00:37 EDT 2019 | rgduval
Generally, the machines can place the same types/sizes of components. The advantage with the 11 is that you can have more magazines loaded with more components, and build larger assemblies more efficiently. The -9, though, will get you through near
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Wed Nov 03 16:16:32 EDT 2010 | briansmi1116
I have a Zevatech 720 that was working great until one day a "E9001 the emergency stop button has been pressed..." error popped up when I turned the machine on. We traced out the circuit and found out what board it went to. I found a replacement an
Electronics Forum | Thu Jul 09 11:12:43 EDT 2015 | quaker332007
We have a mydata MY100DX and A Hover-Davis label feeder. I'm have issues picking up the label. The machine will place it fine for a few then stop and refuse to pick up the label. Is anyone using this configuration and if so do you have and points