Electronics Forum | Thu Jun 18 15:04:48 EDT 1998 | smd
| | | We're running into problems with board damage (broken traces, solder shorts) due to pliers and other bizarre tools being used for depanelization. I need some sort of fixture for this. A delrin plate with a slot cut to the correct depth and wid
Electronics Forum | Tue Jun 09 07:35:23 EDT 1998 | Steve Gregory
Hi there Gary, Your solder ball problem is very similar the problem I experienced, but I was using a water soluble paste at the time. It started by inspectors telling me that they were seeing cold solder on some SIMM's that we had built regularly. W
Electronics Forum | Sat Jun 06 09:53:59 EDT 1998 | Earl Moon
GEOMETRIC DIMENSIONING AND TOLERANCING (GDT) Using and applying GDT to printed circuitry and assemblies is very much like applying it to any other design for manufacturing (DFM) or design for assembly (DFA) requirement using concurrent engineering (C
Electronics Forum | Wed Jun 03 07:13:27 EDT 1998 | Tom Tellinghuisen
| We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not al
Electronics Forum | Tue Jun 02 17:36:43 EDT 1998 | Chris Fontaine
| | We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not
Electronics Forum | Mon May 25 23:26:19 EDT 1998 | Jon Gruett
I agree with Mike. They are a dead issue. As a manufacutrer's rep for many types of equipment and 11 years in the engineering field I have seen several attempts to revive the technology (if you can call that technology). Most if not all attemptds
Electronics Forum | Sat May 09 11:54:12 EDT 1998 | Bob Willis
All the comments that have been made a great but I do have to say that much of the problem comes back to the design engineers not designing for manufacture. Centre board supports would have sorted the problem without jigs. | | I am running a board t
Electronics Forum | Fri May 01 22:05:23 EDT 1998 | D.Lange
| I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) | Here's the part that seems weird to me: | -They didn't tombstone onto a termination - they went onto their sides! That's right, both ter
Electronics Forum | Tue Apr 14 15:50:45 EDT 1998 | Bob Barr
Justin, Thanks for the response to my dilemma. For once it's not just me! The parts seem perfectly solderable, but I will try the modification to the profile you suggested. I wonder if the retention clips may be letting loose from the holes they a
Electronics Forum | Fri Feb 27 10:54:38 EST 1998 | Earl Moon
REVISITING MULTILAYER DIMENSIONAL STABILITY AND LAMINATE INTEGRITY It has been said we must learn it all over again and again about every four years. I know Lee Ritchey said that to me about high speed digital circuit design. The same seems true for
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400