Electronics Forum | Sat Aug 27 12:10:55 EDT 2011 | kahrpr
Basically it pretty standard to run through the board. For programmers /manufacturing engineers it’s a catch 22. If you check everything management is complaining it takes too long. If you don’t check management is complaining because of rework and y
Electronics Forum | Thu Oct 27 16:04:05 EDT 2011 | sjs2303
Right folks, i'm sure we have a wealth of experience on here that needs to be tapped into! If you had to give on piece of advice to a fellow SMD operator/production engineer what would it be? I'll get it started, for me you must not over edit packa
Electronics Forum | Thu Jan 26 15:16:56 EST 2012 | raranchado
Anybody knows how to use TiMMS Traceability? We're not using the application anymore 'cause we replaced it but server still up for record retention. The engineer who managed this one already left the company and now customer asking for the records. I
Electronics Forum | Fri Jun 08 17:06:41 EDT 2012 | tombstonesmt
We have many Pillarhouse Jade Mark II's in our facility. Lately design engineers have taken a liking of huge ground planes in boards. Quite honestly with topside heaters some of these boards were impossible to solder. True you can preheat with the no
Electronics Forum | Thu Apr 19 13:12:48 EDT 2012 | hegemon
Funny. Can't imagine an engineer without some clutter in the workspace. While I "get" the 5S paradigm, for myself it would create a sterile, souless, and unappealing place to work. Everything in its place and a place for everything... The principle
Electronics Forum | Tue Jun 12 15:12:47 EDT 2012 | tanderson
We clean (using a pencil eraser) the fiducials on all our PCBs before processing them through a QUAD QSP-2. We're discussing pcb's with our fabricator to see if they have recommendations. Some of our Engineers believe it is the QUAD that's the proble
Electronics Forum | Mon Sep 03 04:05:56 EDT 2012 | omur
The issue has finally been resolved. It turns out that while checking the vision board, our engineers accidentally changed the address of the Analogue Board (which is adjacent to the vision board) - thus, leading to this startup error - with the unh
Electronics Forum | Tue Sep 18 05:54:02 EDT 2012 | sarason
Have you got some modern software to load the unit. My program PCB Synergy can do some of the Panasonic formats but not this one. It takes less than a day to write if you have some files for me to reverse engineer and the file you read it from. Any
Electronics Forum | Sun Sep 30 07:39:00 EDT 2012 | saduquette
Hi bobpan, Just wanted to follow up on my problem. With a bit of reverse engineering, I was able to troubleshhot my board to a faulty trace between the EEPROM and DSP chip. Since it was an 'inner layer' trace I had no choice but to 'green wire' i
Electronics Forum | Wed Dec 26 14:56:03 EST 2012 | larrygroves
Hi, Just wanted to touch base with everybody. Samsung is alive and well and everything is business as usual. Daves contacts are good and of course I am still in charge of service and all of your local service engineers and reps are the same. My n
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
