Electronics Forum | Mon Jun 12 10:38:00 EDT 2017 | highmillr
Getting this error more frequently. Whats causing this?? I have to reset machine every time costing man hours. After resetting its fine but does it at least once a day.
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Fri Jul 27 09:28:35 EDT 2007 | rich7799
I have Mpm ap25hie, s/w ver 7.1a The problem I have is that the machine works fine until I teach or use the pre board stop function. As soon as I use this the machine will not load the pcb to the centre of the work nest. I can manually change boardst
Electronics Forum | Sat Aug 04 08:09:03 EDT 2007 | rich7799
I found the problem... the vx cable trunking was the wrong radius, so when the axis was moving at slower speeds to read pre stop position, the axis was not reading the platen correctly due to extra downward force.. Ive now replaced the trunking and
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Mon Oct 20 15:28:22 EDT 2014 | island2013
We've got a set of manuals here for the AP series. If you would like to borrow them email me.
Electronics Forum | Sun Oct 12 22:08:34 EDT 2014 | cusackmusic
I just got a used AP/C which I guess is also called an AP25? After fixing a few obvious issues, I powered it up, and get a hardware limit error. I have verified that none of the axis are near their limits. Without a manual, I'm not sure where to go
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Thu Dec 30 20:48:09 EST 2021 | openindus
We acquired the machine few weeks ago and it was working fine until the printer won't initialize anymore with "USC park failed" error. It seems that the printer won't respond to "4 MAXY_SP 61,0" message. Is someone has already en
.gif)