Electronics Forum: error mirae (Page 1 of 1)

Mirae 1030 Y-Axis error

Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd

We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois

Mirae 1030 Y-Axis error

Electronics Forum | Mon Aug 22 08:54:15 EDT 2016 | bobpan

More than likely the encoder scale or read head has an issue. Many times.. oil/dirt/water get on the scale and cause a bad spot or bad area. Try to clean the scale with a lint free cloth and alcohol. You should also be able to see the read head and m

Mirae 1010 problem

Electronics Forum | Wed Nov 06 12:58:56 EST 2013 | bobpan

The key to figuring out mirae machine failures 'most of the time' is found in mr-terminal. Is this message from mr-terminal or is this the windows/program software error. Mirae 1010 machines have boot failure problems often. Sometimes if the z positi

feeders

Electronics Forum | Mon Jan 11 12:25:03 EST 2021 | gfe

Feeders Mirae error code E1, don't do the steps, what's the repair

feeders

Electronics Forum | Mon Jan 11 12:27:12 EST 2021 | gfe

Feeders Mirae error code E1, don't do the steps, what's the repair

Calibration of Nozzle Holes on Mirae Mx350

Electronics Forum | Thu Jan 09 08:40:37 EST 2020 | raeesrajput

Hi Every one, Thanks in advance for your help and support. I am getting errors 'Nozzle pick up error' and 'Nozzle release error' on Mirae Mx350. I have been told to calibrate Nozzle Holes using 'ANC' option in the Menu. Ther

MIRAE 1030P

Electronics Forum | Fri May 11 16:05:27 EDT 2018 | aj

questions I asked: “It seems the vision system is not reliable. However, we need to get the procedure to create and debug fine pitch parts such as BGAs anf QFN’s to understand how the machine operates.: Common errors: • Even after doing the vision t

Calibration of Nozzle Holes on Mirae Mx350

Electronics Forum | Mon Jan 13 08:35:51 EST 2020 | griinder

The holes are calibrated in MSetup. Generally, I have never had luck using the auto teach for the nozzle changer. We would teach them each manually. Before doing this, you need to narrow your issue down a bit more. Which head gives you this error?

MIRAE 1030P

Electronics Forum | Fri May 11 16:06:09 EDT 2018 | aj

answers: The software on these machines is kinda flakey and the manuals are almost useless. There are a lot of bugs in the vision software that bite you. I supported mirea/meridian equipment at a past job and my memory is a bit fuzzy, but here are

  1  

error mirae searches for Companies, Equipment, Machines, Suppliers & Information

Sell Your Used SMT & Test Equipment

Repair tools for all your electronic circuit board repair needs.
IPC Training & Certification - Blackfox

Easily dispense fine pitch components with ±25µm positioning accuracy.


Best Reflow Oven