Electronics Forum | Wed Nov 15 10:51:44 EST 2000 | jackofalltrades
Have you tried using offsets to begin to move the head away in the Z axis while it is moving in a lateral ( X Y ) direction. The spikes are difficult on the Ersa, but experiment with hitting the location from different directions may help also.
Electronics Forum | Thu Apr 25 22:41:24 EDT 2013 | jaimebc
Evtimov, thanks for your reply. Yesterday was our first day of running 99.999%. We were running for weeks with 99.99% Nitrogen purity and we just were having all kinds of problems with the miniwave not being consistent. We had a wave offsets at 75,
Electronics Forum | Thu Apr 25 22:42:06 EDT 2013 | jaimebc
Evtimov, thanks for your reply. Yesterday was our first day of running 99.999%. We were running for weeks with 99.99% Nitrogen purity and we just were having all kinds of problems with the miniwave not being consistent. We had a wave offsets at 75,
Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
Electronics Forum | Mon Apr 29 13:56:19 EDT 2013 | williamaxler
We have a Versaflow 40/50 and ours is setup like this. We have out nozzle test position set so that in the Z axis you are 3.8mm away from the pin. Used feeler gauge Then you can set your gradient per nozzle. Start with a number then do a wave offs
| 1 |
