Electronics Forum | Thu Mar 25 16:10:31 EST 1999 | Chrys Shea
| I have not been good at this and I assume others have not either, so I figure I'll mouth-off about it, even though I'm probably the only jerk on SMTnet that doesn't visit SMTnet Banner Advertisers. | | I believe that we need to visit SMTnet Banne
Electronics Forum | Mon Mar 29 07:08:59 EST 1999 | Wayne Bracy
| | I have not been good at this and I assume others have not either, so I figure I'll mouth-off about it, even though I'm probably the only jerk on SMTnet that doesn't visit SMTnet Banner Advertisers. | | | | I believe that we need to visit SMTnet
Electronics Forum | Wed Mar 18 11:53:29 EST 1998 | Mike Masters
Is there anyone out there required by their customer to clean the finget tab contacts even after using noclean paste? We have been asked to clean even though we don't have any flux residue on the contacts. Any ideas? Mike
Electronics Forum | Fri Dec 20 12:12:12 EST 2002 | russ
Thanks Dave, I was looking in the Murata data base and couldn't even find the part (Even though they are the ones making it)let alone the pad dims. This part looks like it could be fun anyway. Russ
Electronics Forum | Tue Feb 08 06:43:56 EST 2005 | dhanashekar
we have even tried with 6mil stencil even than we are getting the solder ball thanks for your suggestion
Electronics Forum | Mon Apr 24 01:12:28 EDT 2006 | fastek
Sure...I can help. Reduce the temperature and the error will go away. Seriously though.....I'm not sure that oven is even capable of those temps. Is it even convection?
Electronics Forum | Thu Mar 15 10:28:46 EDT 2007 | cecil
Just askin but why would someone even want to subject an assembly to even 6 reflow cycles? As far as how many cycles that an assembly can be subjected to, wouldn't that be determined my your components?
Electronics Forum | Mon Nov 26 09:45:46 EST 2007 | jseagle
My advice is the technology is not there unless your boards have been designed for laser soldering. Even then there are too many limitations to go into it. We tried a unit for almost a year and were never able to get consistent, not even going to m
Electronics Forum | Tue Sep 23 16:16:17 EDT 2008 | snsmt
anything works...thanks! so how do i even start writing a program from scratch? i have no idea what the data means, so there would be no way i would even attempt to write one.
Electronics Forum | Mon Nov 07 13:54:31 EST 2011 | kahrpr
You need to find out what is not compliant about the part. Also some parts can be compliant even though they are not stated to be. Even if the leads had a tin lead finish it may not be enough to make it not compliant. Anyways there is not any body in
