Electronics Forum | Mon Sep 16 13:29:37 EDT 2013 | larrygroves
a lot depends on the age and type of equipment you are using . Older equipment can have a lot of problems with smaller parts. If all is well with your feeders and machine you should expect something like 99.8 to 99.9 percent. some parts will be ident
Electronics Forum | Wed Nov 13 15:33:08 EST 2013 | mondalaci
Good question :) I'd say with a machine that is available for an average pick and place operator nowadays. Our manufacturer is not fixed yet, that's why I don't have any specific. On a related note I'm wondering whether the machine is so importan
Electronics Forum | Thu Apr 17 13:30:30 EDT 2014 | anvil1021
in our opinion unless the Nikon machine has a solution to the Xplane ability to use Tomosynthesis there is a huge difference in the 2 machines. Xplane is a huge quality enabler and we have people beating our door down to get us to look at their perce
Electronics Forum | Thu Apr 17 07:51:19 EDT 2014 | emeto
Opens are on the device to the PCB - mainly on the edges, that makes me think I get some kind of warping,but even if I bake parts and boards doesn't help. We also tried different reflow profiles - same results. I hear that some people use dip fluxers
Electronics Forum | Tue Feb 24 09:47:45 EST 2015 | rgduval
Well, since you're looking at a water soluble flux from AIM, I'm guessing you wash the boards before you conformal coat them. Thus, I wouldn't expect any interaction between the excess flux that you're washing off of the boards and the Humiseal that
Electronics Forum | Mon Oct 19 10:23:24 EDT 2015 | atekcare
Great message that all should pay attention to, I know we do here and have for many, many years knew that good communication and expectation setting was the foundation of satisfied customers. I'd like to hear more about your independent services bus
Electronics Forum | Tue Jul 25 12:46:14 EDT 2017 | emeto
This is easy experiment. Just run no populated PCB and that a populated one using the same spot for your thermo-couples. If you have a convection oven, you might be surprised how small this difference could be if not none. In some cases, I would expe
Electronics Forum | Tue Dec 19 15:55:28 EST 2017 | emeto
Please, don't go this route. It will be not the machine that you expect. If it is Chinese good machine, you should be able to find distributor close by, if it is a clone of a well known machine, they will have problems selling it to you. Man Corp and
Electronics Forum | Wed Jan 31 02:56:53 EST 2018 | robl
Hi Fluxgate, Doubt it's the laminate unless you have embedded components. Nickel is ferromagnetic (can be magnetised),so I would expect some level of magnetism in ENIG, but not silver. Are you 100% sure it was immersion silver and not something
Electronics Forum | Mon Apr 09 09:39:40 EDT 2018 | justconmac
Having an issue with tracking for the Vitronics Soltec Delta 3. Wave will not give error on "expected PCB at exit" but will still show 1+ pcb's in the wave when the machine is empty. This is causing solder pump to idle unnecessarily. Outfeed sensor i
.gif)
