Electronics Forum | Thu Apr 28 04:16:53 EDT 2016 | sarason
Which chemicals do you need and what process are you running? PCB manufacture is a fairly well understood , but there are quite a few complex processes. To end up with a board. there are a few small specialist suppliers like Think/Tinker and MG Chemi
Electronics Forum | Sat Mar 21 09:09:40 EDT 2009 | davef
Your puzzlement about blowholes in PTH solder connections during reflow soldering comes from: * Boards are hydroscopic. So, moisture content of the board is uniform. * Gold plating is uniform. * Nickle plating is uniform. * Copper plating on your PTH
Electronics Forum | Sat Mar 29 08:38:28 EST 2003 | davef
Iman When you talk about your profile, can we assume you're measuring it on the pads of LGA? Profile the solder paste reflow by placing a thermal couple under the component pad, similar to a BGA. On a slight tangent, as with soldering BGA, paste
Electronics Forum | Sun Apr 12 10:44:44 EDT 2015 | proy
I have a small PCB which has gold finger edge connector along one side. This limits the PCB fabricator panelization due to the bevel required on the edge connector Does anyone know of a simple process to add the bevel AFTER the boards are assembled a
Electronics Forum | Mon Mar 04 17:52:59 EST 2002 | davef
Yes, providing the surface of the via is solderable. * If so, how much paste? => Vias come in various sizes. Boards vary in thickness. So, the amount of paste to fill a via varies. Roughly, you�ll need twice as much paste as the volume of the via
Electronics Forum | Mon Jun 18 04:21:22 EDT 2012 | brettrenishaw
Measured the pot temprature independantly from the software (268C/514F from moving wave). We are using Dross Inhibiter Tin/P Regenerator from BLT. Monthly sample checks are carried out on the solder bath and are all within limits. It will be hard to
Electronics Forum | Thu Jun 14 15:29:29 EDT 2012 | davef
That you can get good solder flow when hand soldering seems to indicate that the temperature of your solder pot is too low. Still, I'm uneasy that you see gold on the pads after passing the board across the solder pot. Gold is so thin with ENIG. So
Electronics Forum | Tue May 30 21:09:30 EDT 2000 | Dave F
Dennis: Direct metalization is more of an European phenomena than a US one. Not to say that good things don�t come out of Europe. As background: Direct Metallization. In circuit board fabrication, an alternative to electroless plating makes the
Electronics Forum | Fri May 08 09:44:23 EDT 2009 | davef
Board fabricators use solder as a resist to protect copper traces from process chemicals. Fabricators remove this resist in later processing. It's possible that board fabrication processing is the source of the tin that you see.
Electronics Forum | Thu Aug 20 09:47:46 EDT 1998 | Dave F
| Will somebody please explain HASL (here). Thanks. Tryin: HASL: Hot Air Solder Leveled. A board fabrication process that applies an oxidation preventing solder coating to copper pads on the board. Dave F
winsouce.jpg)
.gif)