Electronics Forum | Mon Sep 18 17:55:55 EDT 2000 | Dave F
Reworking BGA with hot air systems (ie, AirVac, SRT) is fairly complicated and requires fairly rigorous process control. Please compare and contrast BGA rework using hot air and your laser based system.
Electronics Forum | Wed May 25 17:42:44 EDT 2005 | jsloot
They are a CP40 and CP50. The CP40 is fairly new and the 50 is fairly new but we bought it as a used piece. It is in good condition. As far as I can say everything seems set up correctly. By the sounds of your reply I should dig into this more deeply
Electronics Forum | Tue Jun 15 13:36:30 EDT 2004 | John S
We are launching a new product and are fairly new to reflow soldering. A concern that has arisen is a fairly consistent solder ball that forms at an electrolytic capacitor. We changed to a homebase aperture design on our passives to eliminate mid-c
Electronics Forum | Thu Jun 14 06:41:28 EDT 2007 | davef
No, raising the solder pot temperature to 800*F will not affect affect your solder alloy. We expect that you had a fairly high level of intermetallic compound generation, but most of that would be included in the fairly high dross generation that ha
Electronics Forum | Tue Dec 17 00:47:19 EST 2013 | tktak
What are the typical environmental regulations in the US for reflow exhaust if any? We are using a lead free process although I assume it has more to do with the flux than the alloys used. Do we need to look into something like a Title V permit?