Electronics Forum | Wed Jun 24 08:28:16 EDT 2020 | pickplace
Hi Jacobo, it would be importatn to know what kind of error the machine is displaying. Are the chips in paper or plasic tape? Did you check pickup coordinates and hight? Have you many false edge pick vision errors? Then I would switch off the tombest
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
Electronics Forum | Tue May 05 14:57:48 EDT 2020 | greezmky
I will have to check the nozzles to see if they are stuck up, but I don't believe so as I changed them all out a couple weeks ago. I have not went back to the feeder yet because I am not getting vision errors. I was able to see the diodes fly off on
Electronics Forum | Thu May 07 10:48:07 EDT 2020 | greezmky
Yeah my post disappeared as well? I checked to see if there was an offset and there was not. I tried step mode and all was good. I DID get to capture one video in, slow motion, and it shows the part being placed, the nozzle rising, and then when
Electronics Forum | Tue Jun 23 22:14:16 EDT 2020 | kumarb
Hi. Guessing that you are operational by now? If not, consider to use BGA definition and use the editor to define where the bottom side pads are or are not. Just our 2 bits input. The Assembleon X / Yamaha units are quite flexible - using an electron
Electronics Forum | Mon Jun 29 15:33:28 EDT 2020 | jmelson
WOW, thanks for the documents, this will REALLY help selection. It looks like I want the FLX2011CV, that makes it a lot easier to set up and not have to reach into the machine to load and unload boards. The machine footprint is really compact, 10 m
Electronics Forum | Mon Jun 29 19:15:19 EDT 2020 | emeto
The only way is to get a whole system that is smart - there are several out there. I had Mycronic towers, Mycronic machines and smart feeders and all is connected together. Plus the machine measures values for all passive components. Once machine mak
Electronics Forum | Tue Jul 21 20:39:42 EDT 2020 | jmelson
Yes, but they really only seem to be interested in dealing in PPM-refurbished Quad IV C machines. They will sell parts but don't seem to be very interested in supporting other models under the Quad label. (The QSA-30 was made by Samsung, but uses Q
Electronics Forum | Sat Aug 22 16:53:32 EDT 2020 | jmelson
I'm trying to diagnose a Quad QSA-30A machine that won't go ready. I have the machine technical drawings, they have overall machine schematics and cable wiring on most of the cables, but that's all. Does anyone have access to the schematics of the
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411