Electronics Forum: feeding (Page 1 of 47)

bulk feeding chips

Electronics Forum | Mon Feb 03 10:28:21 EST 2003 | gregp

The advantages of bulk feeding vs. tape and reel are numerous. Who is currently employing bulk feeding? If you are, what is the application (HVLM, etc..)? If you are not, why not? I am leaving this question very open initially in order to recieve a

bulk feeding chips

Electronics Forum | Wed Feb 12 10:03:47 EST 2003 | stefwitt

Greg, you pointed out yourself the many advantages of bulk feeding. I would like to mention that the higher component accuracy and the feeding track accuracy of the bulk feeder contribute to an improved pick failure rate of small ( 0402�s ) component

bulk feeding chips

Electronics Forum | Mon Feb 03 17:30:12 EST 2003 | gregp

Thanks for the reply Jon. You say your "advantages did not cancel out or out measure the disadvantages". What were the disadvantages other than lead time? Another question...you say your are not currently using bulk. Does this mean that you used b

bulk feeding chips

Electronics Forum | Tue Feb 04 12:50:36 EST 2003 | gregp

OK Jon, now let me speak hypothetically. We are in agreeance that bulk feeding can save money through increased machine up time. If this cost savings alone could pay for the bulk feeders (it is just a matter of time before it would) and the minimum

Bulk cassette feeding

Electronics Forum | Thu Nov 10 10:03:02 EST 2005 | R.Powers

Hello, I am a high volume user of bulk component feeding. We are going to be changing some of our feeding interfaces and I need to find suppliers of SMD cassettes. I need someone who supplies just the plastic cassette, not components in a cassette

bulk feeding chips

Electronics Forum | Mon Feb 03 16:58:14 EST 2003 | jonfox

Application...oh, we are a high volume, low mix (HVLM). Forgot to answer that one earlier.

bulk feeding chips

Electronics Forum | Fri Feb 07 17:05:57 EST 2003 | gregp

Pick up correction (as far as position) is already available on newer model chipshooters. This doesn't address upside-down fed resistors. The link I provided for Murata tells a story of increased reliability and reduced cost. As components get sma

bulk feeding chips

Electronics Forum | Fri Feb 21 00:34:59 EST 2003 | fastek

Why don't the component manufacturers simply mark the values on both sides of the resistor? Can't be that difficult.

bulk feeding chips

Electronics Forum | Thu Feb 20 12:59:29 EST 2003 | gregp

Claude, I know alot of equipment manufacturers that would like to talk to you about replacing all of your chipshooters! Of course, this will never happen. There probably won't be any sold until all of the used chipshooters are absorbed from the use

bulk feeding chips

Electronics Forum | Thu Feb 06 17:16:41 EST 2003 | gregp

I do not know about the cost issues but as I recall the tolerances are tighter on bulk components and this usually means higher cost. I cannot find my bulk feeding summit information but these links give you some idea what was discussed. I don't kn

  1 2 3 4 5 6 7 8 9 10 Next

feeding searches for Companies, Equipment, Machines, Suppliers & Information

Selective soldering solutions with Jade soldering machine

High Precision Fluid Dispensers
pressure curing ovens

Best Reflow Oven
SMT feeders

High Speed Precision In-Line SPI System - Mirtec MS-11
SMT spare parts

Low-cost, self-paced, online training on electronics manufacturing fundamentals