Electronics Forum | Tue Jul 10 09:00:47 EDT 2012 | stentech
until you know if you stencil does align with the pads on the board all the fids in the world will not help you. registration is key. We do it a lot at our facility in Toronto as we have lots of measuring equipment. In cases like this. We lay the ste
Electronics Forum | Tue Aug 07 09:44:44 EDT 2012 | parmar01
Hi All Im new to the forums, And this my first thread. im the production manager at Broyce Control Everything ive learnt about wave soldering is by trail and error i know its not the best way but it has worked for me. The problem i have been
Electronics Forum | Mon Dec 10 13:23:51 EST 2012 | ericrr
Thank you ENIAC for your input. The engineer who did the PCB says all his figures are correct. I over came the problem by moving the X coordinateness of the 2nd BOC mark (top left on the picture) over just slightly in the file (measured by the dis
Electronics Forum | Thu Dec 20 12:14:37 EST 2012 | dhopps
If you go with MCS I would recommend using an MCS30. You would have to make sure that the E-Proms for host communication are installed in the MCS and the host module (software)as well. You would then need CadConvert to program and transfer programs
Electronics Forum | Fri Jan 18 21:13:51 EST 2013 | ngineer
I was trying to set up a new board, and after creating the board directory, the CC spit back a line of garbage and said the directory was invalid. I pressed escape to start over, and it froze. Now when i start it every time, it goes through login a
Electronics Forum | Mon Jan 28 13:13:19 EST 2013 | chifutbol
I am just being introduced to GemLine and Assembleon. I have been trying to get the programs on two other computers so we get more work done. One is windows 7, the other is vista. I was unable to get PCP explorer or editor installed on the windows
Electronics Forum | Sat Feb 16 22:19:11 EST 2013 | mdang
Hi, I bought a fuji Flexa v4.6.0.7 and hook it hook it up with CP65 machine. The flexa system already have CP65 configure so I can see the production program on the machine and delete them but I can not transmit a new program to the machine. It error
Electronics Forum | Thu May 09 15:44:23 EDT 2013 | redman123
Hi all, Using I-pulse M20. Can anyone advise if stock profile can be outputted in constant text format? Currently can output CSV file but format is not as desired. Other outputs give quantities but not locations or stock code. Would like something li
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Tue May 21 15:30:21 EDT 2013 | williamaxler
There is two different ways to make this work. To get the Add Project button enabled find your EasyOLP installation folder and modify OLPoptions.ini change MultiProject to 1. Now you will be able to add multiple jobs together and optimize. You c