Electronics Forum: finger cleaner (Page 1 of 4)

wave finger cleaner solution

Electronics Forum | Tue Jul 29 14:20:04 EDT 2008 | jstano

What chemical is everybody using in their wave solder finger cleaner? I have tried IPA as well as some other chemicals. Any suggestions?

wave finger cleaner solution

Electronics Forum | Tue Jul 29 22:13:59 EDT 2008 | davef

IPA is a fire hazard. Be sure your fire extinguishers are charged and your evacuation plan is current, when using IPA in the vacinity of a wave solder machine. Have you tried DI water? Solutions used in wave finger cleaners include: * Techspray SMT

wave finger cleaner solution

Electronics Forum | Wed Jul 30 09:07:14 EDT 2008 | grics

Zestron's Vigon RC-101...Good with no clean

wave finger cleaner solution

Electronics Forum | Wed Jul 30 12:13:38 EDT 2008 | allwave

You may want to try C8502 from Kyzen Corp. I use it on our three wave solder machines with great results diluted in DI water 50%. I am an end-user like you not a sales person! You can order free samples... -George

wave finger cleaner solution

Electronics Forum | Thu Jul 31 02:40:20 EDT 2008 | JH pbf

We use Axarel 2200 as recomended by Vitronics Soltec, which is the same as we use on our MPM printes for under stencil cleaning. It is non-ozone depleating and has a high flash point. For insurance purposes we banned IPA from the shop floor some

wave finger cleaner solution

Electronics Forum | Thu Jul 31 07:53:34 EDT 2008 | ck_the_flip

Jon, Does Axarel 2200 leave minimal residue or clumps on the wiper paper area? Also, what is your wipe frequency on a typical board?

wave finger cleaner solution

Electronics Forum | Fri Aug 01 09:44:42 EDT 2008 | pjc

Try Zestron Vigon RC 101. This mixes with tap water. Electrovert does not recommend DI water due to its corrosive nature. http://www.zestron.com/fileadmin/zestron/overviews-tis/usa/ti/ti-vigon-rc101-usa.pdf

wave finger cleaner solution

Electronics Forum | Wed Jul 30 10:48:39 EDT 2008 | wavemasterlarry

Degeaser isn't a good chemical to use either cause it leaves a residue so don't use it. alcohol works good. Not sure why everyone thinks it blows up. heck i remeber back in the day when I hade 24 inch foam fluxers bubbling flux and alcohol (IPA no

Solder on gold finger

Electronics Forum | Thu Jul 20 05:04:30 EDT 2006 | bing007

We had a similar problem with gold contact pads. Cleanliness is paramount. If you are using foil tensioning system, wash the foil in a stencil wash before use as the cardboard cassettes may be contaminated. Be very careful when loading into a frame f

Re: Solder on gold finger

Electronics Forum | Mon Jul 27 17:09:20 EDT 1998 | Rin

We are trying to reduce the number of units fail at system test due to flux on gold finger. We know so far that the flux is deposited onto the goldfinger during touch-up or rework and to reduce the contamination we are planning to imp

  1 2 3 4 Next

finger cleaner searches for Companies, Equipment, Machines, Suppliers & Information

Reflow Ovens

Software for SMT placement & AOI - Free Download.
Industry 4.0 Reflow Oven

High Throughput Reflow Oven
Sell Your Used SMT & Test Equipment

High Precision Fluid Dispensers
Green Monster Stencil Wiping Rolls

Thermal Transfer Materials.