Electronics Forum: fitness (Page 1 of 111)

press fitting connector

Electronics Forum | Tue May 28 11:36:46 EDT 2002 | floydl

Hello Jim, Is any special tooling required for press-fitting a connector?

Soldering failure in time (FIT)

Electronics Forum | Tue Dec 14 20:31:53 EST 2004 | davef

The FIT we mentioned is for a stocked, finished good item. It's for something shipped to a customer.

SMD Push fit connectors

Electronics Forum | Tue Aug 24 20:12:12 EDT 2010 | davef

What is a "SMD push fit connector?"

PCB THICKNESS

Electronics Forum | Thu Oct 21 19:18:05 EDT 2021 | rwyman

Or, it may not fit where it's supposed to fit. That would not make for a happy customer!

Soldering failure in time (FIT)

Electronics Forum | Tue Dec 14 10:58:56 EST 2004 | Peppe

Thanks for your answer Dave. Just a clarification. Given FIT is for just one soldering or for a specific number ? I mean cards we produce have, typically, 10000 soldering joints. Which is the expected FIT of that card ? Thanks again for your help.

HASL board for Press Fit

Electronics Forum | Mon Jan 22 03:51:16 EST 2007 | Bing

We are using HASL board for Press Fit, without problem in the past until recently. Now we are seeing the solder in the PTH melt and block partially the PTH hole during the reflow. It gives problem when Press Fit. Anyone has advice on this?

HASL board for Press Fit

Electronics Forum | Mon Jan 22 09:35:34 EST 2007 | saaitk

Check that your boards haven't been over plated. Too much plating in the hole can slump to the underside of the board during reflow. If you are then press fitting on the underside of the board you can have problems with hole diameter. If the hole is

After a bit of printer pneumatics chat

Electronics Forum | Fri Aug 24 07:21:51 EDT 2012 | leemeyer

The barbed fitting will work but you will lose all control over the speed of the cylinder. The air control flow valve is essentially the same as the barbed fitting but it allows the user to adjust the volume of air that is supplied to the cylinder wh

Problems getting selective nozzles off

Electronics Forum | Thu Jan 03 14:19:33 EST 2013 | uksolder

Beej, The tool supplied works well as long as the bath is up to temp and the nozzle tip was not cross threaded when fitted. Did you apply a small amount of the anti seize paste before the nozzle tip was fitted? I have seen dry tight threads if not ap

Press fit parts help

Electronics Forum | Tue Oct 14 08:27:32 EDT 2014 | kkay

We use a few different style of press fit connectors, terminals, studs, etc. We use a tabletop arbor press for most everything we do, but a lot of times we will see some measling or slight delamination around the holes for the press fit part. Is ther

  1 2 3 4 5 6 7 8 9 10 Next

fitness searches for Companies, Equipment, Machines, Suppliers & Information

Blackfox IPC Training & Certification

Nozzles, Feeders, Spare Parts - Siemens, Fuji, Juki, Yamaha, etc...
High Throughput Reflow Oven

Reflow Soldering 101 Training Course
Win Source Online Electronic parts

Software programs for SMT placement and AOI Inspection machines from CAD or Gerber.
Circuit Board, PCB Assembly & electronics manufacturing service provider

World's Best Reflow Oven Customizable for Unique Applications