Electronics Forum | Wed Sep 30 06:25:14 EDT 2015 | strongbyte
I am looking to buy a Flexible magazine for a Mydata TP9-UFP I have seen both TMCFlex and TMDFlex magazines available, does anybody know the difference between the two and whether they are compatible with my machine. I spoke to a Mycronic engineer
Electronics Forum | Mon Jul 11 13:21:40 EDT 2016 | bradholland
well there you go. I found that trying different values in the "Placing Stroke" had a big effect. I changed it to 2mm and it placed them well, but I could see the board also flexing a little, went to 1mm and the problem came back, so have sat in th
Electronics Forum | Sat Oct 08 11:57:58 EDT 2016 | davef
A friend in the contract coating business said: "... ask why the wire is [teflon] coated in the first place, as only the solder joints should be coated in this situation as the flexing/bending of the wires will cause the coating to crack and flake of
Electronics Forum | Wed Feb 01 02:11:38 EST 2017 | Rob
Hi Joshua, No, the adhesive lasts 2 or 3 runs. The adhesive is put on manually as is the kapton. It's a big panel for a flex - nearly 300 x 210, so the operator loading the boards onto the pallet and fixing them (then into a buffer) stays well ahe
Electronics Forum | Fri Nov 03 13:58:25 EDT 2017 | mattmunoz2013
Hello, I am currently in the process of purchasing a plasma chamber for the purpose of activating the surface of flex circuits so that they bond more readily. In addition I need to purchase a gas cylinder for the chamber, specifically one that is a
Electronics Forum | Fri Aug 10 18:17:43 EDT 2018 | tey422
I am sorry to hear that they are unable to help you out too. If you do came up with the doable solution later, be sure to let me know about it too. I would like to learn new trick or knowing which house that can handle such task.
Electronics Forum | Fri Nov 15 22:05:09 EST 2019 | alanyang
Flexible circuits assembly is different from rigid board assembly. For some manfacturers, fpc assembly are some things more painful because the assembly quality is unstable. Recommend to check and hope these 2 blogs are helpful. Flexible Circuit Asse
Electronics Forum | Fri Dec 20 17:09:52 EST 2019 | slthomas
I agree, that is not a gullwing lead in the normal sense but that doesn't address the failure. The wetting looks fine unless there is a problem under the lead, which is hard to tell since there is an obvious fracture. That appears to be the edge o
Electronics Forum | Fri Jan 31 10:04:14 EST 2020 | emeto
Jinesh, My initial suggestion is you have too much solder past. Please try to reflow a few of these parts without solder paste. Colse aperture, put some tacky flux on this part location and give it a try. I bet you will not see any voiding.
Electronics Forum | Thu Feb 27 15:14:53 EST 2020 | SMTA-Alex
This happens with either old tape, the cover tape doesn't stay sealed on the left side, or is the seal is too far to the right, the knife lifts the cover tape. There isn't much you can do in this case. Your choices are: switch the component into an A
