Electronics Forum | Tue Dec 28 21:02:15 EST 1999 | Jim
Hi Rick, Water soluble flux is heatee, deionized water. So, use DI, and keep it heated. It is also important that the water be moving, so that fresh water is continually being presented to the fluxed surfaces, and the flux-laden water is continually
Electronics Forum | Thu Nov 11 17:17:11 EST 1999 | Boca
1. Most ionic testing is measured in NaCl, that is, the ionic residues are quantified in terms of NaCl equivalence. The test does not determine what the ionic residue is, just its relative strengh. 2. I use IPC cleanliness specs on OA fluxes but n
Electronics Forum | Mon Sep 20 08:21:52 EDT 1999 | Mohammed saad
Hi all, We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. We are producing VGA cards and mother boards for PC's all components to be wave soldered are TH, the SMD is done
Electronics Forum | Mon Mar 15 16:01:06 EST 1999 | Earl Moon
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Mon Mar 15 09:55:53 EST 1999 | Justin Medernach
| After rmoving a BGA (plastic)to correct unexplained shorts | I installed another BGA using flux only. | Checking on an X Ray machine and found two shorts. | | can anyone give a good explenation ? | | Thanks | | Ron | Ron, It could be a number o
Electronics Forum | Sun Apr 05 18:36:41 EDT 1998 | Graham Naisbitt
Sylvia, I believe you will find that contrary to Scott Cooks submission, that the work carried out by Robert Clark of Hughes Missile Systems at (then) Tuscon Arizona formed the basis of the MIL-F-14256 spec which "Qualified?" or at least "Approved" O
Electronics Forum | Wed Jul 24 22:45:54 EDT 2002 | davef
WS609 is a wonderful paste. J-STD-001, 4.2 states words to the effect that for Class 3 products Type H or M fluxes should only be used for tinning operatins. Most water soluable fluxes are either H or M. I believe that you can use Type H or M flux
Electronics Forum | Fri Jan 24 16:46:21 EST 2003 | MA/NY DDave
Hi, Distance Engineering is always difficult. I am guessing that the old machine and process ran wonderfully / acceptable. If you still have the old machine, how about running an empty board through it and then the new machine. Without flux observ
Electronics Forum | Mon Apr 28 09:59:04 EDT 2003 | davef
Your customer's question is reasonable. Soldering to nickel is not always a walk on the beach [can of corn, or whatever]. This issue is flux not solder. Your Sn63 will have plenty of strength, providing the solder connection is well formed. You s
Electronics Forum | Wed Mar 24 20:19:09 EST 2004 | Ken
I recently did a no clean flux eval and by far the leader in the category for remainder (residue) was Interflux 2005MZ 1. You first mission is to provide acceptable solder joints. 2. Only apply what you need to achieve acceptable results. Spray f