Electronics Forum | Tue Nov 03 16:28:21 EST 1998 | Dave F
| Well my process is I'm running my belt speed at 3.50fpm and about 215 to 225 degrees top side. I got my main wave down to a little less than half the board thickness. I'm not using a hot air knife cause we thought it might create more of a problem
Electronics Forum | Fri Oct 13 05:21:08 EDT 2000 | Robert Steltman
Looking at the original post, it seems that the white residue is formed on the board after wave soldering and becomes evident when it has been left standing for a while. From what I understand, it seems that the solids content of the "no clean" flux
Electronics Forum | Fri May 05 14:30:11 EDT 2000 | C.K.
I'd have to disagree with the Electrovert applications guy. I'd recommend SLOWING down the conveyor between .5 to 1 FPM - effectively, you're REDUCING contact length (because contact length = dwell time * conveyor speed), hence getting better peel-o
Electronics Forum | Wed Nov 11 00:42:15 EST 1998 | Jason
Mike, We retrofitted all of our waves with USI spray fluxers. We are running no-clean on 4 of our waves, and OA 2331-ZX, reduced specific gravity to .825, on the other 2 With OA you must buy a special spray head to accomadate higher pressure and l
Electronics Forum | Mon Jul 20 20:58:54 EDT 1998 | Dave F
| | Dave: | Wayne is correct with his analysis of ultrasonic spraying - we also use Sonoteks. However, your post didn't ask for a different system, just a clarification regarding your problem. What type of flux system are you currently using - s
Electronics Forum | Mon Jul 20 20:58:49 EDT 1998 | Dave F
| | Dave: | Wayne is correct with his analysis of ultrasonic spraying - we also use Sonoteks. However, your post didn't ask for a different system, just a clarification regarding your problem. What type of flux system are you currently using - s
Electronics Forum | Tue May 22 12:47:52 EDT 2007 | cyber_wolf
Is there anyone out there using this ? It looks like they only sell it for the 643 machines. Can it be adapted for 642 machines as well ? We have 2 major problems: 1. Operator makes width change adjust without removing supports from previous job. Ta
Electronics Forum | Thu Feb 15 02:19:50 EST 2018 | Robl
Hi Leadthree, We have a combination of methods depending on volume, value, size, level of build, and what the customer does with them. So on high volume low value we have rigid plastic ESD boxes with lids, foam lined, that layers of custom vac form
Electronics Forum | Tue Nov 14 14:08:44 EST 2023 | hhudson
Good Morning, I'm a relatively new engineer, and i've been experiencing a lot of anomalies when it comes to our inline wash. We have an Austin American Hydrojet, and no matter how many times i clean the tank, it still foams like crazy! its been happe
Electronics Forum | Wed Mar 01 17:29:30 EST 2000 | Eldon Sanders
Thanks Dave for your reply. I have found a supplier that can cut it, but I am trying to save the tooling cost and the minimum purchase dollar ammount imposed by the supplier. If an off the shelf item existed I could buy what I wanted when I wanted.
