Electronics Forum | Wed Mar 24 16:28:06 EST 2004 | davef
No-clean flux residues can be either cleanable or not cleanable. The not cleanable type leave a milky white residue on the solder connection after suitable soaking in water. Your flux supplier will have suggestions on the appropriate flux.
Electronics Forum | Wed Mar 24 16:50:08 EST 2004 | davef
RA and RMA flux residues are "sealed" in a hard, glassy coating that do not require cleaning in many end-use environments. That being said, automotive, automotive underhood, and deep well are in that [ascending] order the three most burtal environme
Electronics Forum | Thu Mar 25 10:25:46 EST 2004 | sjpence
For lead tinning services you might want to try: www.sixsigmaservices.com www.corfin.net Both of these companies will re-tin SMT.
Electronics Forum | Fri Mar 26 11:02:56 EST 2004 | Peter
Hi, does anyone know what an L9 on an A-Case tantalum capacitor means? We have a 2.2uf but dont know what the voltage is. Thanks for any response.
Electronics Forum | Fri Mar 26 14:40:00 EST 2004 | Willy
I am looking for a PCB fab shop capable of .65mm through-holes and very close tolerance internal spacing.Anyone out there?
Electronics Forum | Wed Apr 07 06:06:46 EDT 2004 | mattkehoe
I would like to discuss this with you. Could you provide contact information or contact me off line? Matt Kehoe mkehoe@sipad.net 770-475-4576
Electronics Forum | Sat Apr 03 05:21:33 EST 2004 | mattkehoe
There is a method for VIP you may not be familiar with. I dont want to go into depth here but check out http://www.sipad.com/sipadvip.htm and contact me off line if you want more info. Good luck. mk
Electronics Forum | Thu Apr 01 17:15:05 EST 2004 | ricardof
What programming systems are you using now? F4G is no longer supported, so I guess that's not a relaible option to move on. FUJICAM is currently in good shape, most of the bugs are cleared
Electronics Forum | Sat Mar 27 00:36:54 EST 2004 | Eric
Hi, I'm looking for an equipment to check on all the chip and ic placement pressure. Pls advise where can i find this type of equipment. Thanks.
Electronics Forum | Mon Mar 29 12:29:05 EST 2004 | Donn Bellmore
Placement pressure can be checked by using load cells. Both PCP and Entran make them and the amplifiers. They can be contacted at the following websites. PCP http://www.pcp.com Entran http://www.entran.com