Electronics Forum | Wed Apr 06 03:51:27 EDT 2005 | Rob
We have a very expensive MRP system that can (allegedly) do this, so naturally we also use an excel spreadsheet, which includes feeder loading times, 1st off inspection, printer set up, overhead recovery, machine time etc.
Electronics Forum | Mon Apr 04 08:35:08 EDT 2005 | py (france)
how to replace a qfn on a board , and how to weld it ? special stencil solder cream and as a BGA ?
Electronics Forum | Mon Apr 04 12:16:32 EDT 2005 | DasonC
We make a custom mini stencil to print the paste onto the QFN and flip over to load on the rework station. The mini-stencil was designed for SRT to pick up the QFN. Check BeamOn (stencil house) for detail. Good luck
Electronics Forum | Mon Apr 04 08:45:42 EDT 2005 | jimih280
how does polyurethane used for wood floor coating differ from urethane conformal coatings sold for circuit boards? where can i get uv tracer to put in oil based urethane?
Electronics Forum | Mon Apr 04 13:06:01 EDT 2005 | davef
Here you go: * Wood sealing http://www.paintdocs.com/webmsds/webPDF.jsp?SITEID=DURA∏no=86300000&doctype=MSDS〈=E * Board sealing http://www.mgchemicals.com/msds/english/liquid/4223.pdf
Electronics Forum | Thu Apr 07 16:31:36 EDT 2005 | halal
Thanks for your answers! I will see them, and I'll write soon what I found helpful.
Electronics Forum | Thu Apr 07 14:26:21 EDT 2005 | pjc
This should be the Ultraclean II H2O that Electrovert had made by Tooltronics. If so, I may be able to get a manual from 1989 machine.
Electronics Forum | Tue Apr 05 05:19:30 EDT 2005 | blueflag
Breakdown help machine will not 0 set upper end point limits on Z axis Theta / lower end point missed Thanks Colin
Electronics Forum | Tue Apr 05 12:45:01 EDT 2005 | cyber_wolf
Make sure your matrix tray is up high enough. The components in the matrix tray should be at least at board level. Also check your component height in the package list. If all that is OK then, check those Z locks I spoke of earlier.
Electronics Forum | Thu Apr 07 08:57:06 EDT 2005 | blueflag
have been through somethings with an engineer on the help desk and the concusion is that it is the z motor with the encoder that is causing the fuse to go so have ordered another. Not cheap though at nearly �500. Thanks very much for your help, it