Electronics Forum | Thu Mar 23 23:21:10 EST 2006 | AR
100 cm/min) the motor runs without complaint. Too bad we run the conveyor as slowly as 10 cm/min... I'll try replacing the control board next when I get my hands on one.
Electronics Forum | Fri Mar 24 08:10:12 EST 2006 | mapell
Hi AR Nice job on the chain/rail cleaning. I would contact Speedline Electrovert tech support, 800.737.8110 to assist in trouble shooting. They can walk you through using a meter to measure input and output current to the SC card and make sure tha
Electronics Forum | Mon Mar 27 09:35:11 EST 2006 | cyber_wolf
The only problem with the Tribol is PB Free profiles. At thses temps, the Tribol smokes and stinks bad. It also has a tendancy to carbonize. I find myself having to use easy off to clean the chains.
Electronics Forum | Mon Mar 27 11:24:59 EST 2006 | mac
Had similar issue with Omniflow. Was actually jostling tall electrolytic caps off of pads. Found that idler sprockets/pulleys needed lubed.
Electronics Forum | Tue Mar 28 04:49:39 EST 2006 | AR
All's well that end's well: I replaced the Dart speed controller card and the problem disappeared completely. But no harm in giving the chains and the rails a thorough scrub although they weren't the culprit in this case. Many thanks to everyone for
Electronics Forum | Mon Mar 20 12:32:54 EST 2006 | vortex
We recently aquired a Hollis Polyclean II inline washer. We did not receive any manuals or schematics. If anyone has ANY information about this wash I would greatly appreciate it. Thanks, My email is sLarochelle@Itronics.us
Electronics Forum | Tue Mar 21 05:56:24 EST 2006 | aj
Hi All, Can anyone advise what the most suitable Vision type to use on QFN32 inspection Fuji FIP3 Machine. Also the P=Pattern.. Thanks in advance, aj...
Electronics Forum | Tue Mar 21 13:23:46 EST 2006 | Tech
Place it as a square. Vision type 10. Why would you even try to inspect leads on this? It's not like they could get bent.
Electronics Forum | Wed Mar 22 03:36:05 EST 2006 | aj
Hi, Thats the way I have been placing it but we have seen a few misplacements failing in test and I am trying to improve the placement accuracy and consistency by locating the leads/pads . aj
Electronics Forum | Tue Mar 28 14:25:36 EST 2006 | vickt
Mike, These ovens were originally manufactured by ETS...I think you can still get Tech support from that at either 763-553-0051 (MN office) or 509-276-2015 (WA office). Best of luck. Todd
.gif)
