Electronics Forum | Tue Jan 23 20:57:12 EST 2007 | asir
Can some of you kindly share some of your experiences with PbF PCB finish (OSP, ENIG, Immer Sn, Immer Ni,etc.) What are the benefit and disadvantage? Some of the issues that has been encountered. Which one you would recommend?
Electronics Forum | Wed Jan 24 10:16:18 EST 2007 | russ
immersion silver has become my favorite finish for lead free. Seems toi have good shelf life is stored in the silversaver paper. and reflows real well. Russ
Electronics Forum | Sun Feb 04 17:30:07 EST 2007 | greg york
The wetting problem is strange, is the metal in the pot a golden/yellow colour? what temp are you running the pot at? cheers greg
Electronics Forum | Wed Jan 24 16:37:58 EST 2007 | MelS.
Does anyone know of facilities that just perform rework? I am in need of reworking approximately 1,000 panels in the greater Philadelphia area. (two components - one press fit connector, one a samll cap) Any input/advice would be helpful.
Electronics Forum | Fri Jan 26 09:57:25 EST 2007 | rgduval
Mel, SpinPCB Solutions in Hudson, NH. http://www.spinpcb.com. For the sake of disclosure, I am the Manufacturing Manager here at Spin. We specialize in short run, prototype, and ECO/rework assemblies. ..rob
Electronics Forum | Wed Jan 24 20:23:49 EST 2007 | seth
Is Total Force setting necessary, and is it depend on the board thicknes? Is it making any different as far as printing goes? My boss have it set on 8.00 for all 4 MPM, and we are running different type of PCB everyday. Some of the boards thicknes is
Electronics Forum | Thu Jan 25 18:59:15 EST 2007 | seth
Thank you for responding. You guys know where I can get marble track ball mouse that compatible to the Hi-e? We bought the logitech from Best Buy that is not working. We had to use the regular mouse that is so irritating.
Electronics Forum | Fri Jan 26 11:44:12 EST 2007 | chrisgriffin
If you so some searching, you should find a recent thread on this. Try e-bay or PPM. Good luck.
Electronics Forum | Wed Feb 07 09:45:50 EST 2007 | billyd
...and, bake those parts. A lot of times, moisture will cause problems like you mentioned in the center of the part. (Old components will get this condition often)
Electronics Forum | Thu Jan 25 12:50:45 EST 2007 | stepheniii
What about the relay that controls the heater? I've seen that problem on conceptronics ovens. The relay would latch on and never turn off.
