Electronics Forum | Tue Aug 18 17:40:52 EDT 2009 | jlawson
Is the mechanics ok with the raising and lowering into the vapour ie no small movements that could be moving the part ? Most Vapour Machines have a lower and raise mechanisim so movemnt of parts can happen if not smooth, especially when coming out o
Electronics Forum | Wed Aug 19 16:07:58 EDT 2009 | davef
We don't know dip about vapor phase soldering, but we can't help but wonder how well the leads of the component match with the pads on the board.
Electronics Forum | Thu Aug 20 04:37:03 EDT 2009 | sergey2007
Hi, I also paid attention on the solder balls.. I thought it was because of the pop-corning, but the customer told me the component was not damaged.. Regarding the bunch of tented vias, I need to ask the customer about that. Probably, they have unpo
Electronics Forum | Thu Aug 20 19:07:29 EDT 2009 | smt_guy
reduce the stencil aperture to prevent tombstoning in vapor phase process. from my experience a 6 mil thick must be at least between 20 to 30 % aperture reduction for 0805's and below. cheers!
Electronics Forum | Tue Aug 18 12:14:59 EDT 2009 | zanolli
We are looking for suppliers of liquid vapor degreaser batch equipment for flux residue cleaning of PCB’s. Any recommendations? Thanks
Electronics Forum | Tue Aug 18 13:43:52 EDT 2009 | victorp
Is there a standard (such as IPC) or common industry practice in regards with x-out marking on rejected boards of a panel? Do board shops have to X-out both sides of the rejected board, or one side? If the answer is one side, which side should be ma
Electronics Forum | Thu Sep 03 08:39:53 EDT 2009 | markhoch
I'd be more concerned with the pcb itself then I would be with standard SMT components. Are you using a PCB with a high Tg? (170 degrees C or greater)
Electronics Forum | Thu Aug 20 07:10:46 EDT 2009 | davef
Questions are: * On what portion of the second side of the board [eg, solder only, solder mask only, etc] do you see this white hazy residue? * Could you attach a picture? * You mention cleaning this residue. What have you used to clean the residue?
Electronics Forum | Thu Aug 20 08:24:07 EDT 2009 | padawanlinuxero
Hi ! In both solder mask and solder joint, I am going to upload a picture today promise, I use only IPA and a ESD brush this kinda clean the problem
Electronics Forum | Thu Aug 20 08:42:32 EDT 2009 | voytek
Do you know if I can use Multi Pitch Tape Feeder from GSM2 platform on GSM and GSM1 platform? Thank you,