Electronics Forum | Tue Oct 02 10:51:31 EDT 2012 | jimmyboz
What machine? Normally part height in the parts description would dictate placement pressure. In general, paper provides a better centered pick-up but may interfere with the pick-up(paper fibers)
Electronics Forum | Fri Sep 28 10:04:14 EDT 2012 | dwelch123
Looking for some help. I'm getting no power to the main machine. All power supplies are getting correct power in but not outputing power. All output terminals on power supplies read 0V. The main transformer outputs all check with proper voltages. At
Electronics Forum | Fri Sep 28 21:30:35 EDT 2012 | dekhead
Assuming you are not seeing 240VAC @ PSU inputs. Present @ transformer, but not much beyond CB1 on Y4... Nothing to PSU's or PC, etc. Inrush suppressor(s) (Thermistors). Contact me directly. www.dekhead.com
Electronics Forum | Fri Sep 28 15:44:33 EDT 2012 | tzawaide
Hi all... I'm in the market for a tape and reel machine; which is whole new animal for me. Looking for recommendations for a good quality and reliable piece of equipment. Your input is greatly appreciated!
Electronics Forum | Fri Sep 28 17:39:44 EDT 2012 | hishamuddinjohari
Hi, I cannot find the following SMD semiconductor marking code 'H890' somebody help me
Electronics Forum | Mon Oct 01 03:19:02 EDT 2012 | garretlunod
Hi.. Can anyone help me regarding Mirtec AOI MV-3L. we are encountering software crashes and slowing down of inspection speed and loading of program also.
Electronics Forum | Wed Oct 03 19:13:52 EDT 2012 | swag
Could be your drive(s) getting full. The individual program files and picture files used on those machines are huge.
Electronics Forum | Thu Oct 04 20:22:45 EDT 2012 | hegemon
SWAG may be correct. The program files, the defect data, and images do pile up. You will also experience this is you have a lot of components that are not linked to your libraries. These too will add up over time, and cause considerable slowdown. '
Electronics Forum | Thu Oct 04 14:26:45 EDT 2012 | capse
hi, The 2D uses gray scale analysis to calculate area coverage of paste on the pad. Off-line programming was offered via CircuitCAM from Aegis.
Electronics Forum | Tue Oct 02 03:35:05 EDT 2012 | benreben
Hi all, depending on your experience is there a difference between CP642 and CP643? what is the most stable machine service level? there know problem with these machines? Thanks Regards,