Electronics Forum | Wed Jan 02 09:16:05 EST 2013 | dan_ems
Thank you, I already ask for the software, but maybe because of the holidays I don't have an answer until now. Sarason, I still waiting for the original software but is good to know that there are alternatives.
Electronics Forum | Thu Jan 03 11:25:07 EST 2013 | dontfeedphils
That's weird, I've never had any problems using the tool while the pot is up to temp. Over-tightened? They don't need to be tightened too much when putting them in.
Electronics Forum | Thu Jan 03 11:28:11 EST 2013 | beej
I have had a couple like this. It almost seems like they are not threaded correctly. I had to mangle the last one just to get it off.
Electronics Forum | Fri Jan 04 07:28:46 EST 2013 | beej
Thank you guys. I will check this stuff out. It quite possibly could be something we have done wrong. Thanks again for the feedback
Electronics Forum | Fri Jan 04 10:39:37 EST 2013 | dontfeedphils
We've got used MPM Accuflex that we recently purchased and it seems like the stencil to board offsets need to be calibrated. After looking into the manual it looks like it requires a fixture or calibration jig, can anyone confirm this? Does anyone
Electronics Forum | Fri Jan 04 15:20:04 EST 2013 | dontfeedphils
Any idea where the global offsets are entered? Under the vision setup there are print offsets, but these seem like they would be program specific, which is something we're looking to avoid since we will be running two machines networked. Thanks for
Electronics Forum | Mon Jan 07 08:23:37 EST 2013 | cyber_wolf
You should be able to find this in the utilities menu under calibrate machine. (If your software is the same as my Momentum) If not, give MPM service a ring. They will help you.
Electronics Forum | Fri Jan 04 14:42:20 EST 2013 | mcox
Philips Gem Topaz - Does anyone have a decoder ring for calculating the correct place angle for components. I am looking for a fool proof way to program the correct angles depending on how the parts are supplied to the machine. Thanks Mike
Electronics Forum | Sun Jan 06 19:12:14 EST 2013 | jhengst
What parts are you having problems with. FYI. I have glass plate cal kit for sale if you know anyone interested?
Electronics Forum | Fri Jan 04 21:17:10 EST 2013 | kahrpr
you can use any IDE drive. you can call the guys at samsung there are a bunch of numbers for them a few posts back
