Electronics Forum | Sun Dec 21 04:19:52 EST 2014 | leadthree
When I worked for a company that did alu-wire dice bonding they used a brand called Hysol for encapsuling. It needed heat cure. It's extremely hard to remove. As far as I remember it's epoxy based.
Electronics Forum | Thu Dec 18 14:38:58 EST 2014 | rangarajd
Hello, I don't have any experience with Juki. Visited one of their booth recently and I was told they use a laser for alignment. How does this work? Is there any advantage over the traditional vision alignment? Thanks!
Electronics Forum | Sun Dec 21 23:30:09 EST 2014 | sarason
Since the Laser alignment bit is attached to the head and you don't have to move the part to a camera location, before placing the component on the board it is about the fastest method there is of getting accurate component alignment. With more moder
Electronics Forum | Sun Dec 21 23:24:38 EST 2014 | sarason
Try the Zevatech group on Yahoo https://ca.groups.yahoo.com/neo/groups/zevatech/files Buena Suerte sarason
Electronics Forum | Mon Dec 22 04:55:41 EST 2014 | bobpan
Swap the amps but first manually check by hand to make sure the z-axis is free to move up and down. Sometimes a part can get stuck in the gears. Good Luck
Electronics Forum | Mon Dec 22 22:05:42 EST 2014 | slouis2014
What could be the possible solution for shorted BGA but only appears on the component corners. The BGA is 18mm x 18mm in size.The component solder balls are within specs and the pad design for the BGA is with standard. How can I solve this problem
Electronics Forum | Wed Dec 24 10:38:01 EST 2014 | jimpat
Assuming its 285 Celsius as measured at the solder joint, you are overheating the die. If 285 C is your ovens setting then you need to measure the BGA package peak temperature as well as the joint temperature.
Electronics Forum | Wed Dec 24 12:01:36 EST 2014 | emeto
Hi, I think that the jet printer is going to work for your process - the key with this device is to maintain it really good so you don't get any clogs. These are very fast devices.
Electronics Forum | Sun Dec 28 12:29:10 EST 2014 | luca2006
Hi, No im still waiting that someone uploads installation software or gives me a valid link to download
Electronics Forum | Sun Dec 28 19:13:03 EST 2014 | kahrpr
Its been a long time but a CP40 will not run under XP its win 95 or win98 only and I believe it can only use the original style mother board.