Electronics Forum | Thu Feb 02 22:24:57 EST 2017 | dekhead
My earlier response was relative to the operational passwords... not to the password you are, apparently, looking for. Forced to ask "why" you need (what do you need to setup???) the "machine SetUp Password". You can do more harm than good, in most
Electronics Forum | Wed Feb 01 00:21:12 EST 2017 | shahrat
Hi, Between Vitronics Soltec & Heller which reflow oven would be be better for mobile phone production?? Can anyone give me the answer with technical reason. Thanks
Electronics Forum | Wed Feb 01 11:38:07 EST 2017 | emeto
It is hard without specifying the models and the options on them. These are two of the top manufacturers out there, but there are even better, so if you are going to make a mass production assemblies, you should make a much bigger research.
Electronics Forum | Fri Feb 03 16:55:20 EST 2017 | westshoredesign
We have 6 Vitronics Soltec ovens. 4 XPM 820's, an XPM 1240, and an XPM3. All of them are great, but we're very impressed with the XPM3, you can't go wrong.
Electronics Forum | Sun Feb 05 06:00:59 EST 2017 | jlawson
I would look at Rehm Thermal Systems, they are the leaders in Reflow and offer systems at same pricing points as XPM and Heller now with VXC series ( uses same tech as there top end VXS/VXP range...
Electronics Forum | Sun Feb 05 13:38:13 EST 2017 | shahrat
Thanks for ur good advice. I do have a Tamura, one JT, 3rd one I want to buy Heller or Vitronic. Using KIC also for profiling.
Electronics Forum | Sat Mar 18 12:09:48 EDT 2017 | jchris
Of course D Levanthal you would say this ... considering you are the NY Manufacturer's Rep, a salesman for Heller in the New York area!
Electronics Forum | Fri Mar 24 08:58:49 EDT 2017 | spoiltforchoice
Out of curiosity, what get JT on the list compared to other Chinese brands? e.g Folungwin Chuxin (Seems to be sold unbranded by quite a few) Dektec Or a Korean one like TSM .
Electronics Forum | Tue Mar 07 09:21:28 EST 2017 | buckcho
Hello, it is similar to the normal ones. You just have to collect 2 thermo profiles for each side and decide in the middle, so all your component heat requirements are met. Sometime it is very hard if the panel has a big variation in components.
Electronics Forum | Wed Feb 01 06:52:36 EST 2017 | cyber_wolf
Has anyone had any success polishing scratches out of a Juki laser ? If so, how did you do it ? Thanks in advance