Electronics Forum | Tue Jun 09 16:29:03 EDT 2020 | dilogic
Since rear feeder bank can be in three different positions, machine must know which one it is. Check in Machine Setup, Parameters - Feeders (see attached image). It that's set wrong, machine will try to reach position out of range and will hit end sw
Electronics Forum | Tue Jun 09 16:48:56 EDT 2020 | bboyer
All ready resolved. Looks like there was a loose cable on one of the modules, which would not allow it to command the low voltage servo module to run the motor in reverse.
Electronics Forum | Thu Jun 04 02:16:43 EDT 2020 | SMTA-Robert
Looking for CTE and young's modulus values for aluminum backed PCB for solder joint predictions. The data sheets are a bit sparse, and the weighted average method somehow doesn't feel appropriate. Any advice is welcome. Thanks!
Electronics Forum | Wed Jun 24 15:16:51 EDT 2020 | SMTA-Dave
The typical CTE below Tg is 40 ppm/K and 110 above Tg ppm/K. The typical modulus is 16 Gpa
Electronics Forum | Fri Jun 05 12:32:14 EDT 2020 | leandroxp
Hello people! how to solve problem of disconnects system. machine SI-G200? https://uploaddeimagens.com.br/imagens/aeO3o2c
Electronics Forum | Sun Jun 07 21:56:43 EDT 2020 | bobpan
email me and i will guide you through the troubleshooting. www.precision-repairs.com Bob
Electronics Forum | Tue Jun 09 07:10:46 EDT 2020 | ameenullakhan
Hi Team, Please recommend some good solder paste viscosity meter.Which easy to use and user friendly. Regards, Ameen
Electronics Forum | Fri Jun 19 22:10:18 EDT 2020 | davef
Don't get yourself wrapped around the measure solder paste viscosity axel. Observe the paste handling and preparation instructions provided by your solder paste fabricator.
Electronics Forum | Mon Jun 22 05:04:57 EDT 2020 | ameenullakhan
Hi Dave, Thanks . But it's one of our customer requirement to have in house solder paste viscosity measurement. Regards, Ameen
Electronics Forum | Mon Jun 22 15:53:35 EDT 2020 | cyber_wolf
This would be a highly unusual "requirement." In house checks on paste viscosity went the way of the buffalo years ago. The question to your customer should be: why ? All of the mainstream paste suppliers should be able to supply you with a COC th
