Electronics Forum | Tue Dec 06 09:37:21 EST 2005 | dougs
we looked at the mirtec when we were selecting our AOI machine, it is a good machine, we eventually settled on an MVP GEM, comparable price but very powerful machine, we place down to 16thou pitch and 0402 and the MVP's solder joint inspection on the
Electronics Forum | Wed Dec 07 14:56:35 EST 2005 | rhorowitz
Dear Mr Duckman, I am a Regional Sales Manager with MIRTEC. I would be happy to discuss your application with you. If I can be of any assistance, please feel free to call or e-mail me at your convenience. Respectfully, Robert Horowitz 203-881-5559
Electronics Forum | Fri Dec 09 16:38:20 EST 2005 | Csommers
I looked at Yestech and Mirtec. Evaluated both products and decided for Mirtec. After using the system for a couple of months I decided to send it back. There is a lot of problems with bugs in the software, falls calls are in the high numbers and the
Electronics Forum | Mon Dec 05 09:22:35 EST 2005 | BReiman
Does anyone know of any resources that will come into our company and provide a gap analysis between the RoHS requirements and our current processes and proceedures? We have done a lot of work so far but we want to make sure there isn't something we
Electronics Forum | Tue Dec 06 02:59:09 EST 2005 | darek
Lately we purchease second hand CSM 84V. During placing parts, we notices that few components are damaged (mmelf, 0805). What we done: - the position of pcb was decreased - the jaws moved little bit outside. Components after that are still damaged. H
Electronics Forum | Tue Dec 20 07:58:32 EST 2005 | dwensker
Thank you all for your info. Our problem is fixed. We did as you mention: - chuck set correctly on the collers, Wide jaw Soft spring & Narrow jaw hard spring - make the pick-place soft - slow down the speed controllers for both descent and ascent r
Electronics Forum | Tue Dec 20 12:09:33 EST 2005 | randygray
Hello, I have a CSM 84VZ for sale. This machine runs except for a sensor problem in the Z upward motion when you attempt to zero the machine. Please let me know if you are interested and I will send you complete details. Best Regards, Randy Gray
Electronics Forum | Wed Jun 06 12:56:04 EDT 2007 | appliedi
Good Morning: We are looking at trying to find someone to service our CSM-84VZ and were wondering if you knew of any techs we could call who would walk us through the service process over the phone? Thank YOU Mark Chisholm mark@appliedi.com
Electronics Forum | Tue Dec 06 08:35:17 EST 2005 | geb
Hi, I have put a new camera into a Universal GSM(1) machine, but it takes up an extra feeder slot either side. When optimising itself it does not know that a feeder won't fit there. Does anyone know how to tell it not to allow feeders in certain slot
Electronics Forum | Tue Dec 20 08:26:17 EST 2005 | geb
Thanks for the info. Yes the old camera was a 4mil rectangle, and the new one is a 1mil circle, 2 slots wider. The camera was calibrated on install, but they must have done something wrong, cos it doesn't realise it is 2 slots short. This screws up t
