Electronics Forum | Wed Sep 09 15:07:39 EDT 2009 | petep
With the H1N1 and other flu virus' upon us, our HR department is planning to place hand sanitizers throughout our facilities. I need to assure the planned product is "electronic friendly" and that it will not adversely affect solderability. Pure
Electronics Forum | Fri Sep 18 04:19:33 EDT 2009 | gregoryyork
Glycerine on a PCB is very bad news as it is Hygroscopic and can attract moisture to the Circuit. Alot of this used to be used in HASL Fluxes and is a no go for Circuits that are not going to be washed. They too could dissolve the natural Halides fro
Electronics Forum | Tue Nov 17 19:03:53 EST 2009 | rrlotion
There can be an alternative to putting Alcohol Based Sanitizers made with Glycerin into electronic assembly areas. We are already providing an Antibacterial Lotion to many electronic manufacturers so that there is compliance with handling PCB's as w
Electronics Forum | Tue Nov 24 11:18:54 EST 2009 | 14367
RRLotion, you said you offer an antibacterial hand lotion. I looked at your web site and no where in the literature for your hand lotion does it state that it has any antibacterial capability. I looked at the MSDS and there are no active ingredient
Electronics Forum | Tue Sep 22 23:43:46 EDT 2009 | rohitfast
Hi Stephen, Can you pl suggest what exactly needed for the process? There is no any standard method to ensure for the ESD damage. ESDS:2020 is talking about only for persoanl and equipement grounding mechanism, in the process no insulator should be
Electronics Forum | Wed Sep 23 10:48:39 EDT 2009 | scottp
I did see ESD issues years ago when we tried using a plastic stencil to print SMT glue. We measured a huge charge on boards indexed out of the printer. I tried ionizing fans but that didn't help. We now only use metal stencils for printing adhesiv
Electronics Forum | Tue Sep 15 05:11:52 EDT 2009 | srinivasa
hi, if the blower is stuck, check the pully shaft whether it is correctly fixed with fans. if price is concern, you can remove the motor and get it repair by re-winding of motor coil. if price is no concern you can change complete assemly or motor a
Electronics Forum | Sun Sep 13 19:56:21 EDT 2009 | 89jeong
Hi All I have a pig problem after reflow. It is a blister in hole.It happend after reflow(Lead free solder) I touched the blister with tweezer. The plating was lifted off easily How do i do? What is a root casue? Drilling or plating? Is it possible
Electronics Forum | Thu Sep 24 13:24:27 EDT 2009 | markhoch
I can't help but laugh. People ask for help, other people go out of their way to offer assistance, and the people asking for help have so much inexperience that they can't even determine that it was a valid attempt at trying to help solve their probl
Electronics Forum | Mon Sep 21 11:29:52 EDT 2009 | edmneb
The part we are looking for is the touchscreen controller manufactured by Microtouch. There is no specific part number called out in the UIC drawing book, but the part that we found on the PCB of the Microtouch unit was 7209401. We did swap the con