Electronics Forum | Wed Feb 13 09:26:45 EST 2013 | slthomas
All good comments from everyone and all things we're either working on now or know we should but can't because our resources are already stretched too thin. Frankly I hate CAPAs because I hate getting them. Maybe I'd learn to love them if I initiate
Electronics Forum | Sat Feb 16 16:41:36 EST 2013 | ericrr
When I was a little boy I saw a fly on top of another fly, I thought they were fighting, since fighting people make a mess, thinking we can not have fighting flys. So I whacked them over the head with the rolled up advertising section of a newspape
Electronics Forum | Tue Feb 12 12:29:33 EST 2013 | emeto
Hello everyone, I am curious what do you think about stencil type and apperture design for better release on small appertures. I have a PCB with bunch of BGAs with small appertures. We tried with Nikel stencil using DEK's special non stick material
Electronics Forum | Wed Feb 13 14:01:37 EST 2013 | davef
Things that come mind are: * Not sure why you want to do this, since probing solder gives a longer probe life than probing copper. * I've never tried it, but I see no reason why you couldn't probe Kapt0n or blue painters tape. * Fabs [or you] can pri
Electronics Forum | Thu Feb 14 09:24:58 EST 2013 | adrianus
Hello, We need information regarding the specifics of soldering Nickel Silver in a reflow process. Is there a specific process / flux / cleaning / Temperature curve / or whatever required in order to properly process parts from this material? Nicke
Electronics Forum | Fri Feb 15 06:59:07 EST 2013 | davef
Use a standard that everyone will recognize. If you say, "The solderability test was performed in accordance with ANSI/J-STD-002 'Solderabiility Tests for Component Leads, Terminations, Lugs, Terminals and Wires'” [ipc.org/TOC/J-STD-002C.pdf ], every
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Thu Feb 14 17:00:42 EST 2013 | richardc
I am trying to use Mydata TM8C feeders that work fine on a TP93 running 1.6.18 TPsys but are not recognized by a TP94 machine running 1.4.7 TPsys. I get a green flashing light instead of a solid green. I can initialize the hardware but can not proc
