Electronics Forum | Thu Sep 11 16:06:34 EDT 2014 | gregp
Hello Esteemed Panel, I have a question...what is the most cost effective way to get power to a PCB? By this I mean connecting power and ground without a connector but something more reliable than soldering a wire directly to the PCB. Whatever solut
Electronics Forum | Thu Oct 02 15:28:19 EDT 2014 | arifa_anees
it all depends on the situation, your circuitry and components. ground place should always be below or above the signal and power traces to minimize loops and reduce EMI generated by the board.If you have multiple power voltages and a 4-layer board y
Electronics Forum | Wed Oct 08 11:23:21 EDT 2014 | wavemasterlarry
Most stuff i get comes with a plug on it. I usuaslly just plug it in to the wall where the holes are. My cousin Herb syas he licks the two prongs of the plug before he plugs it in. Says to make sur e you don't drool on it or it could shock you!
Electronics Forum | Fri Oct 31 09:14:25 EDT 2014 | gregp
OK...here is an example of something very cost effective and a very reliable... http://zierick.com/pages/sm_ipct.php The wire gets crimped in after reflow which is currently not automated. (WaveMasterLarry...this is the other end of the cord where i
Electronics Forum | Thu Oct 02 15:17:22 EDT 2014 | arifa_anees
you can find it on different sites, for refernce some are given below: www.keller-druck.com/picts/pdf/engl/man_gsm2_e.pdfCachedSimilar https://www.sparkfun.com/.../CEL-09533-User's%20Manual.pdf www.cybrotech.co.uk/.../Manual/GSM-SA%20User%20Manual
Electronics Forum | Fri Oct 03 10:52:32 EDT 2014 | rgduval
Thanks for the suggestion, Arifa. However, it doesn't look like any of these are for the Universal Instruments GSM2 pick and place machine. The Keller-Druck link is for a GPRS Modem with a datalogger. The Sparkfun and Cybrotech sites seem to be
Electronics Forum | Fri Nov 14 12:41:30 EST 2014 | duoman
I also operate a 3/45. In order to flux from the top, you would need to have another system on top similar to what you already have on the bottom. There just isn't room for all of the required equipment. Who did you contact at ERSA? I have always had
Electronics Forum | Thu Sep 18 12:52:08 EDT 2014 | steveO
Does anyone know a rough price estimate on a new nitrogen reflow oven that can achieve very low oxygen levels - around 10PPM. Compared to a similar standard nitrogen oven that would for example go down to 500 PPM, what is a rough price premium for a
Electronics Forum | Tue Sep 30 12:09:45 EDT 2014 | tech1
If you are running a Mydata machine why don't you try one of the new stick magazines they offer. These magazines shake rather than vibe and the motion is controlled by the package dimensions. Call your rep and see if you can "borrow" one to try out.
Electronics Forum | Thu Feb 12 17:07:19 EST 2015 | magan
i found out what was the issue. driver card was bad so, that needs to be replaced. Thanks for support but i still need 'ekra x5' manual if someone carry, please email me. every day& now some other thing needs replacement and for technical understan