Electronics Forum | Fri Nov 07 11:13:35 EST 2014 | dyoungquist
We have run Mydata machines for 10+ years with no ESD damage from the machine itself that we know of. Can you tell us how you have verified it is the machine causing the ESD damage? It seems to me the ESD damage would be far more likely coming from
Electronics Forum | Fri Nov 07 18:12:50 EST 2014 | cot628
This issue is coming from a customer. The customer demands that we do not mechanically center or test passive components, because of issues they had in the past. There has been a studies that it takes about 8-10 newtons to damage chip. Most of our pa
Electronics Forum | Sat Nov 08 00:28:25 EST 2014 | padawanlinuxero
Hello We a Mydata and put all kinda of components with the midas unit, but never had problems with ESD, and some of them are very delicate parts, perhaps like our colleague said perhaps you should look at the trays or feeders that you are using, pe
Electronics Forum | Mon Nov 10 06:54:19 EST 2014 | cyber_wolf
It's called running every day 3 shifts for 22 years. Anyway....My precise numbers aren't handy but lets just say a lot of parts were placed in that time. I would be pretty confident in saying that the centering jaws do not cause ESD damage on Mydat
Electronics Forum | Sat Nov 08 21:48:42 EST 2014 | sonavc
ETC then you see TEACH. But I can't see it. Do my machine need to update the software or chane some thing in the Proper program?. I'm using MCS16 computer. So far the machine runs great , But take me awhile to move to correct fiducial location Thank
Electronics Forum | Tue Nov 11 21:21:54 EST 2014 | sonavc
Thank you, that is help, I always change in program and re-transmit. One more question, I program N_data with capacitor is TANTB (using M nozzles in part data). but when I run the program in machine it is always use S nozzles to pick the cap. TANTB
Electronics Forum | Thu Nov 13 13:12:57 EST 2014 | jimmyboz
Are you using MCS1 or MCS2 software on the MCS16? For MCS1 I would have to try and remember, haven't seen that software in 20 years. For MCS2 in the PD make sure nozzle size, nozzle size min, and nozzle size max are all set to Med.
Electronics Forum | Mon Nov 10 08:53:23 EST 2014 | jpal
We have the opportunity to buy a new selective solder machine and are used to using a very old Jade machine with a moving tank and wetted nozzle. I have two process concept questions: Which is better- move the board over the nozzle or move the nozz
Electronics Forum | Fri Nov 14 09:47:19 EST 2014 | jpal
Thanks for all the remarks. I am tending toward the move the pot method. I am concerned about parts tilting from square if moved or held at an angle. I won't need to deal with board pallets, board clamp mechanisms, etc. Plus I found the moving board
Electronics Forum | Fri Nov 14 10:40:35 EST 2014 | eniac
I use a two machines from EBSO, Germany. It's a machines with PCB carrier, so, solder pot is fixed. I'm fully satisfied with this equipment, but I use only wettable nozzles. If you would like to buy a new machine, not in used condition, EBSO will be
