Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue Oct 17 08:05:22 EDT 2023 | unsung
I don't see your email in my inbox sir. It's a lot to write. Check all your power supplies make sure all of them light up in your machine and Check the Main Start Switch if it correctly works the ignition green button switch you should here a thumb n
Electronics Forum | Wed Oct 18 15:49:51 EDT 2023 | spoiltforchoice
The only thing I can add to this is that I think I have seen a screenshot/video of Hanwha placement software that showed (or appeared to) manufacturer part numbers being used on the machine and alternative handled on that same screen. That may have b
Electronics Forum | Sat Oct 21 17:41:05 EDT 2023 | basil_rv
Hi all! While operating the JUKI JX-350LED, error E600016 (Since the Z-axis is descending, it cannot operate) appeared. During initialization, this error appears, although all heads are raised. Rebooting and turning off the heads did not help. Wha
Electronics Forum | Mon Oct 23 15:03:19 EDT 2023 | davemccabs
Hi everyone, We just acquired a MPM Ultraprint 1500 and dont have manuals for it. It's running SigmaPro 32 v6.3 software. Would anyone please be able to share any manuals for it? Hopefully more than just the operator manual. Thank you!
Electronics Forum | Wed Oct 25 19:36:41 EDT 2023 | samlam
The process of med spa staffing is intricately outlined in the discussions on https://valhallamedics.com/navigating-the-challenges-of-med-spa-staffing-the-role-of-valhalla-medics/ . The page unveils the nuances and challenges inherent in med spa staf
Electronics Forum | Fri Oct 27 14:54:29 EDT 2023 | proceng1
I won't answer your design question, as I don't do PCB design. I will say that if your product is to ROHS, make sure that the connector you choose can handle the REFLOW temperatures required. As a CM, we have had some products that were intended fo
Electronics Forum | Tue Oct 31 19:28:24 EDT 2023 | ttheis
We built our own coating system by mounting a Universal Robots UR5 to an edge conveyor between a magazine unloader and magazine loader. The robot has a needle dispenser on the head. We chose a needle dispense process to avoid aerosols and complex ven
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked
Electronics Forum | Tue Nov 07 06:36:39 EST 2023 | ravikumargv
Dear All. Good day.. We have one Omniexcel dual conveyor reflow and recently we had PC got gone bad and now we replaced new mother board and hard disk, but we don't have the previous PC backup, now we need the software. kindly help us to share the
