Electronics Forum | Mon Oct 03 05:17:50 EDT 2016 | robl
2D SPI? Depending on the focusing height PTH inspection, or PTH solder joint inspection? Strip down if it has a granite slab in and turn into an engineering table for manufactured parts inspection? Stick a router head on it if you are really bored
Electronics Forum | Sat Oct 08 12:42:10 EDT 2016 | ttheis
Well I stand corrected; we tried re-printing mis-prints on Friday with our auto printer and indeed it worked out very well. I did let the paste dry up a bit on the mis-printed board while a few others went through to try and prevent smearing as it re
Electronics Forum | Mon Oct 03 05:10:19 EDT 2016 | robl
Hi Nikhilesh, It was a long time ago, but we used to buy the nickel in reels then had a cut and feed station on the smt machine with selectable sizes. We did many types of boards in very large volumes, and usually the Nickel strip was soldered to t
Electronics Forum | Tue Oct 04 20:31:16 EDT 2016 | davef
IPC-7721, Section 6.1, Jumper Wires, Jumper Wire Selection #5 states: "Recommended wire is solid, insulated, plated copper wire, 22 to 32 AWG with a heat resistant insulation. Wire with tin-lead plating may be restricted due to environmental laws."
Electronics Forum | Fri Oct 07 12:50:51 EDT 2016 | padawanlinuxero
Hello guys I am back! Guys I have a problem with the laser marker here, we use the laser to mark a 2D barcode on the pcbs for traceability, but for some reason since yesterday every time it tries to connect to the database to get the serial codes an
Electronics Forum | Sat Oct 08 04:24:37 EDT 2016 | aaronpainter
We are having an issue with the solder bars hanging the solder feeder dripping down the back side of the pot, and leaking in to the area where the terminal block for the elements on the pot are. We have tried aluminum tape to close off the gap betwee
Electronics Forum | Wed Oct 12 08:34:48 EDT 2016 | assuredtech
Speaking from experience, the solder pot surface has become "wetted" so to speak, so solder will naturally wick and seek. Allow the level to go low (perhaps 1 inch plus), clean the top surface area of the solder pot as best as you can - try to remove
Electronics Forum | Mon Jun 12 07:52:21 EDT 2017 | tch
We have had this issue on our Delta 3 waves and determined that there are small pin holes in the solder pot. We had plates welded to the outside of our solder pot on the lead free wave and this bought us enough time until we could replace the wave, a
Electronics Forum | Sun Oct 09 22:07:51 EDT 2016 | geniepro
I would like to ask after glue bonding is abalibity drop. I test by force equipment that it is very difficult to drop after reflow 2. Very due by DIP machine. I check after Dip many chip drop. I wonder the glue not qualify I am using IR 130. Could yo
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
