Electronics Forum | Tue Feb 20 14:21:54 EST 2018 | deanm
Thank you all for your feedback. While the new smart reel towers are the ideal, we simply cannot afford them or better pnp equipment at this time. However for the short term, probably putting colored stickers on the reel edge folded over so it is vis
Electronics Forum | Thu Feb 22 04:00:21 EST 2018 | robl
Hi Dean, You may be in luck, we have another Infor ERP, Visual, and we have added MSL data via something called USER DEFINED FIELDS in the part record (Part Maintenance). It then comes through onto the part labels. It's worth asking you local supp
Electronics Forum | Tue Jan 30 07:29:21 EST 2018 | charliedci
I believe the correct statement (I've been told) is "the process is no clean". The solder paste is "low residue". As a CM, in the past we had customers that insisted on a wash after soldering. We used DI water with a saponifier which had mixed result
Electronics Forum | Thu Feb 01 03:02:50 EST 2018 | robl
Hi Rob, > > I did check with the board house, and > the confirmed that there was no Nickel plating, > but that the silver went straight onto the copper > in their immersion silver > process. > > Interestingly I've even tested an > unplated sam
Electronics Forum | Thu Feb 01 07:41:01 EST 2018 | dontfeedphils
Interesting, never heard of using wax as a coating mask. Not sure how well the AR coating would hold up to a hot alkaline wash (unless you have experience with it), but that stuff usually starts to flake off/de-wet if you just look at it wrong. I'm
Electronics Forum | Thu Feb 01 09:09:10 EST 2018 | deanm
I'm not sure if your customer will allow it but consider sealing the perimeter of the connector where it meets the board with some kind of sealant or staking material. Cure it then apply tape on top of it. Then all you have to do is remove the tape a
Electronics Forum | Wed Feb 14 15:34:37 EST 2018 | cbart
We have two Wave Solder machines and still use > the FOAMING flux, but the formula we used to use > was discontinued, and the one we are currently > using isn't as good. > > I'm hoping that others > are still foaming and will share what flux >
Electronics Forum | Mon Feb 26 08:58:01 EST 2018 | altus_group
Hi Wnb_Pemgr, I am not sure where your facility is based but I was hoping that we might be able to help with some of your issues? Hopefully we can support you with any ongoing problems you have or escalate any cases you have already made with Koh Yo
Electronics Forum | Sat Feb 10 10:08:04 EST 2018 | griinder
We recently acquired used MPM Accuflex. Immediately I noticed the live vision is mirrored. This makes it incredibly difficult to teach fiducials. I noticed some smudges on the lens, which leads me to believe the camera assembly was "worked on" at som
Electronics Forum | Mon Feb 12 08:37:04 EST 2018 | dontfeedphils
The piece that splits the vision probably has smudges or scratches on it. You're able to teach a set of pads. Before teaching the fid, hit the "Draw Correlation Box" button (I think that's what it's called, it's been a couple years). Then draw a b