Electronics Forum | Wed Aug 23 08:08:25 EDT 2006 | aj
There are a few variables that you have to consider : 1. Hours available on Wave Machine ( are other products going thru the same wave) 2. What beat rate are the boards being supplied from previous station?i.e. do you envisage the waveto be a bottl
Electronics Forum | Mon Aug 28 10:51:51 EDT 2006 | SWAG
http://www.brigarelectronics.com/Merchant2/merchant.mv?Screen=PROD&Store_Code=BE∏uct_Code=GP-MF552&Category_Code=C Seems to be working well. I didn't remove the housing from the machine = recal. The placements are right on, it's just a bit out of f
Electronics Forum | Thu Aug 24 15:54:13 EDT 2006 | davef
It depends. What is: * Storage environment and period * Board laminate, epoxy, and copper thickness of PTH * Down stream process * Etc FR4 0.062" thick boards absorb between 0.08 to 0.1%Wt of moisture within a 24 hour period, and 0.2 to 0.23%Wt in
Electronics Forum | Tue Aug 29 08:11:12 EDT 2006 | davef
"... we've coerced Josh into driving us out to Watson's bay, braving the horrendous parking situation, to visit Doyle's." Good for you, but you could be parking on a sinkhole: http://www.uwsp.edu/geo/faculty/ozsvath/images/winter_park_sinkhole.htm
Electronics Forum | Thu Aug 24 12:53:56 EDT 2006 | russ
yes, it could have been from all 3 locations. without any detail whatsoever about your process or anythign it is impossible to help!! please check your incoming material prior to processing please check your reflow profile to ensure that max temp
Electronics Forum | Fri Aug 25 09:12:07 EDT 2006 | russ
When not practical to drill hole into pcb to profile here is what I do and seems to be just fine. place thermo into area underneath BGA and let her rip, you will not be in the ball/solder joint, but the temp difference as long as you are in the arra
Electronics Forum | Thu Sep 07 08:18:19 EDT 2006 | Rob
Hi Pavel, Great machines - very good for high volume - we did a lot of OEM overflow work and for fault finding & speed it kicked the other more expensive machines into touch. However... Programming is a lot slower initially than some of the othe
Electronics Forum | Wed Aug 30 03:58:26 EDT 2006 | Ola
Yes you do need a different upline interface card. This information should be in Your Technical Reference Manual, Electronics enclosure chapter 6? Y2 Enclosure, card position X8 Downline and X9 upline: Part No Description. 112045 Base Card
Electronics Forum | Thu Sep 07 07:38:14 EDT 2006 | travis1977
I have experience programming and using the yestech system in a high volume high mix environment. The system seemed to work well until I used a more sophisticated system. When I changed jobs and had another opportunity to spec. in paste and post-r
Electronics Forum | Thu Sep 07 09:32:14 EDT 2006 | tony_d
Hello Saaitk, I was recently tasked with selecting an AOI system for our company. We are a low to medium manufacturer as well. I looked at several different vendors and narrowed the field to Mirtec and Yestech. I found that the programming was v