Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
Electronics Forum | Mon Apr 29 13:56:19 EDT 2013 | williamaxler
We have a Versaflow 40/50 and ours is setup like this. We have out nozzle test position set so that in the Z axis you are 3.8mm away from the pin. Used feeler gauge Then you can set your gradient per nozzle. Start with a number then do a wave offs
Electronics Forum | Thu Jun 06 13:04:50 EDT 2013 | williamaxler
I used method 'A' but I leave the wave on. I use a stainless steal brush like 7248T13 on McMaster-Carr.com. This way I can apply the acid and scrub the nozzle. Another important part is get a small brush to push down into the nozzle to make sure y
Electronics Forum | Mon Apr 29 14:36:26 EDT 2013 | bandjwet
I am trying to determine who out there is reballing devices below 0.4mm in pitch. We have been reballing as small as a 4-balled 0.15mm 4 mil ball diameter area array devices using an adhesive-backed reballing preform. 1. For such small devices we h
Electronics Forum | Tue Apr 30 05:05:16 EDT 2013 | pavel_murtishev
Colleagues, Now I am involved into plant ramp-up where 3x Panaconic NPM-W will be installed. New production hall is being designed right now and the problem is that constructors have never met SMT shops and know very few or next to nothing about requ
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Wed May 01 15:27:22 EDT 2013 | lheiss
Hi All, I've been using a IVc for many years. I'm to the point where I have Mod Code 8 = 15, MC9 = 500, and all Extents PU delays set to 40ish. These settings work pretty well but I would like to get them closer to factory defaults to save the los
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Tue May 07 14:57:40 EDT 2013 | davef
Tape & Reel, Reel suppliers: * Advantek advantek.com/products/packaging-reels.php * Peak International peakinternational.com/tape.html * Acrotech Southwest, Inc. - Kerville, TX; (830)896-6464, Fax: (830)896-8245, SBorroum@ktc.com acrotechplastics.com
