Electronics Forum | Mon Aug 17 15:19:16 EDT 2020 | jmelson
I have a (new to me) Quad QSA-30A that I just got about a week ago. At first, I could get it to go ready most of the time, now it will never go ready. I have traced the ready button into the DPRAM board and the logic is OK all the way into one of t
Electronics Forum | Mon Aug 24 17:05:51 EDT 2020 | kumarb
Aurash, we own Yamaha machinery but just throwing it out there...are the movements of the motors smooth or with friction? Is it possible that the linear screw rods (as in our machinery) require to be lubricated? There are special lubricants for each
Electronics Forum | Tue Aug 25 11:31:41 EDT 2020 | stephendo
yes Once I was using dewers of liquid N2 and recommended switching. I tried using air to the machine so the sensor would let the machine run. Boards went from good to a two inch icicle covering a large area. We went to a wall mounted single stage fi
Electronics Forum | Wed Aug 26 20:52:15 EDT 2020 | stephendo
One thing about liquid N2 is while it is safe, only let trained personnel near it. I believe if someone got their hand frozen on the side, it is not coming off until the dewer is completely empty and warmed up. And make sure management understands
Electronics Forum | Wed Aug 26 11:51:57 EDT 2020 | spoiltforchoice
I think this probably depends a bit on what is in an ssa file (no idea personally)and how the machine you are moving to works. For instance if you have intelligent feeders than any data relating to where a feeder is loaded or the best place to put it
Electronics Forum | Fri Aug 28 17:47:59 EDT 2020 | inspiredmorris20
thanks Stephen!! I'm testing for voltage and have found 24v going through the E-stop to the main switch. If i trip the E-stop i can disengage the main switch. I have no more control to the hardware then that. The software is not throwing any code ot
Electronics Forum | Mon Aug 31 03:24:54 EDT 2020 | jmelson
I don't know this exact machine, but it likely has similar logic to some other Samsung machines. The E-stop buttons have TWO sections. One shuts off the "main start" button, the other informs the computer that the button has been pressed. If you d
Electronics Forum | Mon Aug 31 11:52:28 EDT 2020 | inspiredmorris20
Hello Jon, I appreciate your reply, correct there are 2 red (24v) that control the main power and 2 blue (they control the power to the units operation keys ready, start, stop, reset, change feeders.) additionally there is a red jumper wire on the E
Electronics Forum | Sun Aug 30 17:31:15 EDT 2020 | kylehunter
Hi all, (I posted on eevblog also, figured I'd try hear as well since this seems like a semi "niche" question) I need some advice on PCB cleaning. Up to this point, our assembly line has strictly run NC paste, with all SMT parts. We never washed an
Electronics Forum | Wed Sep 02 15:02:36 EDT 2020 | SMTA-64387501
We have recently received some pre-tinned "flat lead packages" and the question I have relates to the definition of solder touching the component body of the part. Typically when I have gold lead parts tinned there is a gold gap between the tinned po