Electronics Forum | Tue Apr 25 13:05:19 EDT 2023 | proceng1
Occasionally we need to verify that the part in my hand is the MPN it is supposed to be. Or I need to figure out what a part is because the part number label is damaged. I had been using smdmark (dot) com with some success, but it appears to be down
Electronics Forum | Tue Apr 25 23:17:52 EDT 2023 | smtusa
So I visited a high tech factory that exclusively used mydata for last 20 years. They started with 1 my9, moved to 3, currently at 8 my200/300s which the whole company was proud of. They love them and credit mydata with the reason they were able to
Electronics Forum | Wed May 03 13:34:04 EDT 2023 | proceng1
When we get a bad print at SMT, the operator uses the alcohol wipes and wipes the paste off the board. Then they use compressed air and another wipe. In most cases this is sufficient. Most vias are tented, but there still remains some solder sphere
Electronics Forum | Thu May 04 01:52:17 EDT 2023 | davef
Look at IPC-7526 - Stencil and Misprinted Board Cleaning Handbook, Misprinted Circuit Board CleaningCLEANING [ https://www.multi-circuit-boards.eu/fileadmin/user_upload/downloads/leiterplatten_design-hilfe/ipc-7526.pdf ] ITW/EAE says "Typically, th
Electronics Forum | Tue May 09 14:30:47 EDT 2023 | gwideman
I realize this request is an incredible longshot, but... Anybody happen to know the initial default username and password for ERSAsoft 2.1? We have a hard-working antique Hotflow 3, and decided to try setting up ERSAsoft for it. Comes on two floppi
Electronics Forum | Wed May 10 01:40:26 EDT 2023 | gwideman
UPDATE: By some miracle, a paper manual has been found for the ERSAsoft 2.1 software. Turns out that the default user and password are "System". So in addition to that gem, I guess an additional contribution of this thread is that despite the manu
Electronics Forum | Fri May 12 07:41:15 EDT 2023 | tommy_magyar
Although I see the advantages in your method, not sure though how to deal with the following: 1. Your batch is actually only one board (or panel) - this would not work in a low volume manufacturing environment, unless there are other jobs set up on t
Electronics Forum | Thu May 25 01:46:10 EDT 2023 | frankchan
Hi, I would recommend something from 21 Century at least. Considering it's mostly small batches there's no reason to raise the budget to purchase the Newest series. I think the principle here is something that'll do and do a nice job. If you are a Ya
Electronics Forum | Thu Jun 01 00:20:25 EDT 2023 | ultraview
We are using a Kayo-A4 SMT machine and are running across software bugs we can't seem to work around. Video here: https://youtu.be/PSobXzTtcH0 I push next and the camera goes to the correct location for part J2. Then I push test and the part is picke
Electronics Forum | Thu Jun 01 22:47:27 EDT 2023 | spoiltforchoice
most, possibly all of our clients, don't specify this kind of thing even when they are in fields where you might expect they should and should be aware of them. However if you cherry pick a couple of class 2 requirements such as offset and joint widt
