Electronics Forum | Tue Aug 02 07:51:03 EDT 2005 | Mark
Add my name to that list as well. I am looking for non-magazine loaders. mmjm_1099@yahoo.com
Electronics Forum | Tue Aug 02 11:11:33 EDT 2005 | ianlg
Hi Try Steven at RE-Surface Technologies he has several Nutek ones in stock according to his equipmemt list he just sent me. His e mail address as as follows steven@resurface.com.au (www.resurface.com.au) Regards Ian
Electronics Forum | Wed Aug 03 10:48:48 EDT 2005 | Rob
Connectors, IC sockets etc. have traditionally use a lot of recycled plastic in them. There are no guarentees that there are no PBB/PBDE's in them, so some manufacturers are having to change back to new plastics. So plastic goes in the ground i
Electronics Forum | Wed Aug 03 08:42:02 EDT 2005 | ianlg
Hi Here is one that can handle the size board that you are looking to print. http://www.reprintservices.co.uk/R29_Series_Screen_Printer.html Hope that this is of help. Regards Ian
Electronics Forum | Wed Aug 03 10:03:25 EDT 2005 | Rob
There's always a used MPM UP3000, they're cheap.... ....but there is a very good reason for this.
Electronics Forum | Tue Aug 02 15:13:09 EDT 2005 | Sandy B
I am looking for a method (Automated preferably) to clean any residue and or debris from a BGA after rework. Is it possible to clean them using an inline wash process, as long as the devices are intact and held correctly. What woudl be the correct m
Electronics Forum | Tue Aug 02 21:37:21 EDT 2005 | davef
Are we talking: * BGA that you've reballed and want to clean prior to attachment to a circuit board? * BGA that you've attached to a circuit board after correcting something or other? ... and we're talking a water soluble flux or what?
Electronics Forum | Wed Aug 03 12:54:20 EDT 2005 | russ
The process flow should be the same for all of these. I will admiot that I did not check each acronym you provided to see if any of these components require some sort of prep first before attachment.
Electronics Forum | Wed Aug 03 08:21:25 EDT 2005 | danhui888
Dear sir, This is Danny Hui from VS Solution. May I know whom did you buy from in China? Regards Danny Hui
Electronics Forum | Wed Aug 03 14:57:54 EDT 2005 | ???
The machine you are buying is probably going to cost less than the service visit. Then with all the problems found......hmmmmm....could get real ugly.......shoulda just bought a new machine.....hahahhaa