Electronics Forum | Thu Feb 22 19:37:48 EST 2007 | vshan
Hi All im facing an issue with my DEK. Once the middle sensor detects the board, the stopper does not able to stop the board on time. i have checked all the basic parameters. Can anyone help me rgd vshan
Electronics Forum | Thu Feb 22 22:01:18 EST 2007 | dekhead
Software version running? Is this on one product or all products? Left to right feed? If yes, is board at left sensor being keyed? Right to left feed? what is setting for "right feed delay", increase it?
Electronics Forum | Thu Feb 22 22:47:37 EST 2007 | vshan
yes left to right sensor on left feed whatelse next can do rgd vshan
Electronics Forum | Thu Feb 22 22:57:59 EST 2007 | dekhead
What software version is running? Assumption it is running with FMI, what is UL protocol? Change UL protocol to "Manual", belt should not start running until board is placed over sensor, confirm! All products or just 1? What is board width of curr
Electronics Forum | Thu Feb 22 23:14:08 EST 2007 | vshan
v4.03 yes ul protocol under manual currently we are running with only one product Board width is 150mm
Electronics Forum | Fri Feb 23 03:13:21 EST 2007 | vshan
if No FMI is that every cycle we have to press confirm, if yes it will effect during production mode rgd vshan
Electronics Forum | Fri Feb 23 07:58:27 EST 2007 | realchunks
Does your camera / stopper move to a spot where it can catch the boad when the middle sensor is triggered? It sounds like you may have your board stop coordinates wrong. Check your X measurement to be sure.
Electronics Forum | Fri Feb 23 08:26:12 EST 2007 | realchunks
No, you can simply replace the bad BGA with a new one. If this is a one of kind BGA and you must use it, then you need to get it reballed.
Electronics Forum | Fri Feb 23 08:56:21 EST 2007 | russ
I persoanlly have noticed issue with either method, only time I run into issues with trays is when they get baked at too high of temp and warp. Russ
Electronics Forum | Fri Feb 23 11:09:50 EST 2007 | James
Does anyone know anyone in the U.S that buys used Jedec trays and Tubes? I would like to recycle these instead of throwing them away. Thanks for any input.