Electronics Forum | Fri Dec 18 14:42:56 EST 2009 | gpost
I would place the TC under the heaviest component if you can - has the most thermal mass and hardest to get to temperature.
Electronics Forum | Sat Dec 26 13:41:22 EST 2009 | cobar
The negative side to tape is that you could have a small airbubble next to the T/C which will result in an inaccurate reding as the air will be hotter than the joint.
Electronics Forum | Fri Dec 11 07:30:45 EST 2009 | vei
I'm in the same situation also. You can use whatever profile in on there already, but not set your own.
Electronics Forum | Mon Dec 14 13:20:56 EST 2009 | stepheniii
Xrays go through aluminum quite well. I've xrayed BGAs with heat sinks that were well over an inch tall and they only made faint shadows. What material is the bottom of the PCB? And how are you going to bond to it?
Electronics Forum | Thu Dec 17 03:20:32 EST 2009 | tod1967
Sounds like a good challenge. What is your interconnect bond method? Solder Paste, Pre-Form/Liquid Flux or Paste, Assuming your using solder. Reflow method?
Electronics Forum | Sat Dec 12 04:47:58 EST 2009 | nkohler
Hello, Somebody would be able to tell it to me, which ones the important differences between the presence examination manners (Classic, ColourMVC, Voting...)? Thanks for your help! Regards, nkohler
Electronics Forum | Mon Dec 14 09:22:04 EST 2009 | jammm
I need to profile a single sided board thats width is less than the profiler. Is there a difference in profiles when one is completed using the rail conveyor versus just laying the board and profiler on the mesh conveyor?
Electronics Forum | Mon Dec 14 18:39:21 EST 2009 | ashworth14
Does anyone know of any good software that i can use to create SMT inspection drawings idealy from a gerber file.
Electronics Forum | Thu Dec 17 15:02:55 EST 2009 | jlawson
Valors vPlan also has applicable valid tools - smt programming ,docs/WI generation, manual placement all possible...
Electronics Forum | Tue Dec 15 06:07:53 EST 2009 | joelinacio
I need to know what is the sot-23-5 in the dmm fluke 189 with the code t6g. It is wired with the com conector.