Electronics Forum | Thu Oct 23 04:19:15 EDT 2014 | garteaga
Our reflow oven builds solder on one specific panel type. It will have solder buildup inside the oven. We then end up with small solder balls on our panels. We think it may be the solder paste, the screen printer is leaving a clean wipe under the pa
Electronics Forum | Tue Oct 28 14:18:41 EDT 2014 | tombstonesmt
Spoke to the maintenance manager, master password is the current date in reverse. For example : Today is 10/28/2014 so... 41028201 Level 3 should be pass3. Hope this helps.
Electronics Forum | Wed Oct 29 10:36:33 EDT 2014 | blainemoran
Looking for a maintenance mode on the NPM-W where I can isolate and fire different components. For example if I suspected a bad motor is there a way to just attempt to fire that. Any advise?
Electronics Forum | Wed Oct 29 18:08:35 EDT 2014 | tombstonesmt
Good afternoon. Not sure if this is available at an engineer level. Perhaps and SD card with field service access is necessary. We have two lines with NPM-W's and the most we've been able to do is actuate vacuum on the heads during flow checks.
Electronics Forum | Tue Jan 06 17:32:44 EST 2015 | tamte65
If you still have the problem: We are Cencorp OEM service department in McAllen TX. Can you provide the machine serial number so we can check more accurate response. The problem seems to be related PC CPU issue. Overheating or something similar.
Electronics Forum | Thu Oct 30 16:20:29 EDT 2014 | sumote
I purchased this AOI at an auction, and the passwords were not included. Does anyone know the default passwords for this machine?
Electronics Forum | Mon Nov 03 08:39:30 EST 2014 | emeto
Looks like you did everything right. Clean and check carefully the stencil for damage close to the part you are having problem with. If not both of your squeegees should be damaged on the same spot.
Electronics Forum | Mon Nov 03 12:58:07 EST 2014 | swag
Nano Protec. It really works. Our operators swear by it. Get a sample from DEK and give it a ride on that stencil.
Electronics Forum | Wed Nov 05 15:47:57 EST 2014 | pnguyvu
Hi Bill, Contact Steve Yen with USA STENCILS INC. He'll help you out. He might need to know stencil thickness and type of solder paste, his contact as below. Steve@usastencils.com 714-636-6211
Electronics Forum | Tue Jan 27 03:16:22 EST 2015 | nvn
Hi, I have same problem like this but i got the solution for my entire google search i hope you to follow this instructions from here. http://driverbasket.com/