Electronics Forum | Fri May 05 02:48:22 EDT 2017 | beckysu
Hi Bukas, If you want to purchase a fiducial camera, please feel free to contact with me. Best Regards, Becky Su
Electronics Forum | Tue Apr 25 08:07:17 EDT 2017 | dekhead
Not a MY expert, but would suspect the computer PSU. DCV drop during boot will definitely cause this symptom.
Electronics Forum | Tue Apr 25 17:09:02 EDT 2017 | tomwd
Is the computer PSU located in BM4CB unit and get the 12v/5v voltages generated from 12v/5v box via the XP5/12v cable?
Electronics Forum | Wed Apr 26 07:32:46 EDT 2017 | bk
If you open up the back panel of the unit where your mot boards and cpu are there is a panel with test points. You can test all the dc voltages there including the 5 and 12 volts ones for the cpu.
Electronics Forum | Wed Apr 26 09:18:19 EDT 2017 | dentata911
Hello Is it possible to make really big placement delay on this maschine? 3-4 seconds? Thank you.
Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L
Electronics Forum | Wed Jun 07 04:44:23 EDT 2017 | dentata911
Thank you for your answer. But maximum value for modcode 7 is 255. 255x3.3 msec is 0.8 sec. And I need 2-3 seconds...
Electronics Forum | Thu Apr 27 05:48:32 EDT 2017 | pavel_murtishev
jin, The answer is no. DOS has to be installed from distributive normally supplied with machine. Hopefully, machine data has not been erased. If it has been erased, than machine will have to be recalibrated. Regards, Pavel
Electronics Forum | Fri Dec 15 08:32:13 EST 2017 | robertorocco
Hi Pavel it is possible to clone the hard disk topaz machine to replace it in the future crashed? how should I do to save the calibration data of the machine?
Electronics Forum | Fri Dec 22 05:24:23 EST 2017 | protokos
Hi ii is possible to clone a hard disk, but the calibration data must be backup first. if this not can, then the machine must be calibrated.